Your Cart Is Empty

BBK Air Intake Systems

Have a Question?
Have a Question? Ask a product expert! (800) 874-8888 Live Chat
  • BBK Power-Plus Throttle Bodies

  • BBK Power-Plus Cold Air Intake Systems

  • BBK Mass Air Meter

  • BBK Intake Manifolds

  • BBK Mustang Intake Manifold Spacers

  • shipping icon
  • Not Rated Yet

 

View all reviews for this product

There are no customer reviews for this product

You may only compare up to 5 products at a time.
Please select at least two products to start comparing.

Latest Customer Reviews

BBK Power-Plus Cold Air Intake Systems Reviews


BBK Power-Plus Cold Air Intake Systems

Reviewed By Carlos Eduardo C (El Paso, TX) Reviewed for a 2011 Ford Mustang —4/10/2015 7:08 AM

I liked this product cause isreally nice for your ford Mustang, the sound after the installation is awesome, looks like very impressive for viewers. It was an easy installation, really good the transit time since they shipped until the delivery home. Really good price in compare other sites, Autoanything has very good customer service representatives.

View More Reviews

BBK Power-Plus Throttle Bodies Reviews


62 MM throttle body

Reviewed By Larry F (Robesonia, PA) Reviewed for a 2008 Ford Mustang —4/10/2015 6:44 AM

Installed on 2008 Mustang Bullitt. Only other Mods have been BBK under drive pulley set and axle back flow masters. Signifcant increase in throttle response - engine could not run any more smoothly - a quality built product. Installation rather straight forward - no retune required. Slight increase in throaty exhaust note! Performance that is well worth the investment. Highly recommend!! Thank you Auto Anything and BBK. Larry Reading, Pa.

View More Reviews

BBK Intake Manifolds Reviews


LS1 intake to BBK intake=improvement / included hardware = poor

Reviewed By Randall L (Middlesex, NC) Reviewed for a 2002 Chevy Corvette —9/10/2013 4:28 PM

Supplied throttle body bolts were too long. Removed 1 cm off the top bolt because it extended out onto the EGR block off plate. Removed .5 cm off the bottom bolts because they bottomed out in the intake before snugging up the throttle body. The shoulders of the intake bolts extended below the intake itself. I used a die to cut the threads up .5 cm on the shoulder. Intake = 85cm Throttle body = 80cm Supplied gasket = 79cm Called BBK - was told "no one else has complained about it"

View More Reviews

Helpful BBK Air Intake Systems Articles