Average Customer Rating |
(951)
|
| Appearance |
 |
| Ease of Installation |
 |
| Price/Value |
 |
| Quality |
 |
Sort By
Posted on 10/21/2009 by Brian M. - 2003 Toyota Tundra (Torrance,CA)
0 of 0 people found the following review helpful.

Appearance

Ease of Installation

Price/Value

Quality
"This is a very good intake kit, fit into my tundra very well, no hassle. The directions were a little shaky but for the most part it was easy to install by myself. took about an hour. sounds like a really loud vacuum going up hills or when the engine is under load. looks shiny and neat. overall love it"
Was this review helpful? Yes
No
About Brian M.
Vehicle
2003 Toyota Tundra
Posted on 10/14/2009 by Jeremy G. - 2008 Toyota Tundra (Waterloo,IL)
0 of 0 people found the following review helpful.

Appearance

Ease of Installation

Price/Value

Quality
"Installation on my 08 tundra was pretty easy. It took about an hour. Putting the rubber piece on the heat shield was a little difficult but everything else went in smoothly. There is a little whistling at low rpms but not bad. I could tell an increase in power right away but no increase in mpg yet. I would recommend this product to anyone looking at cold air intakes."
Was this review helpful? Yes
No
About Jeremy G.
Vehicle
2008 Toyota Tundra
Posted on 09/30/2009 by Robert L. - 2007 Ford Explorer (Scottsdale ,AZ )
1 of 1 people found the following review helpful.

Appearance

Ease of Installation

Price/Value

Quality
"I bought this intake after waiting for a model to be available for an '07 4.6 Ford. It was worth the wait.
Great improvement of power. I am sure there will be mpg
improvement when I keep my foot out it.
READ INSTRUCTIONS COMPLETELY BEFORE STARTING.
They are not correct but you will make sense of them if
you are familiar where all goes."
Was this review helpful? Yes
No
About Robert L.
Vehicle
2007 Ford Explorer
I use my vehicle for
travel
Posted on 09/20/2009 by Sam W. - 2006 Toyota Tundra (Canyon Country,CA)
0 of 0 people found the following review helpful.

Appearance

Ease of Installation

Price/Value

Quality
"Putting the intake on was easy took about an hour and a half for me and I'm 16 and don't know a whole lot about motors, you don't even need the directions. I've noticed an increase in throttle response and mpg (if i could keep my foot out of it) engine noise is amazing right around 3k RPM's. i would recommend to everyone."
Was this review helpful? Yes
No
About Sam W.
Vehicle
2006 Toyota Tundra
I use my vehicle for
everything
Posted on 09/02/2009 by Sean N. - 2001 Ford Ranger (Cambridge,MA)
0 of 0 people found the following review helpful.

Appearance

Ease of Installation

Price/Value

Quality
"Installation was exceptionally simple, unscrew this, slide this on, screw it together. If I could make a suggestion, assemble as much of the new filter housing as you can before you start ripping out the stock intake this way you arent standing at your engine putting the new intake together with a bunch of screws laying around. Overall a great upgrade, definitely increases engine pick up power at low and high speeds, very loud at 3 to 4k RPMs."
Was this review helpful? Yes
No
About Sean N.
Vehicle
2001 Ford Ranger
Posted on 08/29/2009 by T C K. - 2000 Toyota Tundra (Jackson,TN)
1 of 1 people found the following review helpful.

Appearance

Ease of Installation

Price/Value

Quality
"Everything I have always expected from K&N product, I wish the price would come down just a little lower so that more people could be able to enjoy the product. The installation was pretty simple, my truck running great I could almost hear the cold air intake such the air in. I couldn't tell if my truck is getting better mpg, as matter of fact I feel like my mpg is somewhat going down, could be just operator...Would I buy the product again?... of course I also have the K&N cold air intake system in my RSX type S. Love the product!"
Was this review helpful? Yes
No
About T C K.
Vehicle
2000 Toyota Tundra
I use my vehicle for
Bad weather commuting.
Posted on 08/25/2009 by Mike B. - 2008 Toyota FJ Cruiser (Clovis,CA)
1 of 1 people found the following review helpful.

Appearance

Ease of Installation

Price/Value

Quality
"After I installed the cold air intake which was easy, I immediatelly noticed a power increase. The engine howls when I step on the gas and passing other cars is an ease. I cane drive it easy and in normal traffic speed and get better gas mileage than stock setup, very satisfied. MIKE B"
Was this review helpful? Yes
No
About Mike B.
Vehicle
2008 Toyota FJ Cruiser
I use my vehicle for
Mainly for daily commutes to work.
Posted on 08/19/2009 by Joseph B. - 2009 Toyota Tacoma (Stoneville,NC)
1 of 1 people found the following review helpful.

Appearance

Ease of Installation

Price/Value

Quality
"I really like the K&N intake i put on my 09 toyota tacoma. it was easy to install and sounds great. the only thing was the rubber strip that goes around the metal housing for the filter. there just wasnt enough according to the picture. but other than that i love it"
Was this review helpful? Yes
No
About Joseph B.
Vehicle
2009 Toyota Tacoma
I use my vehicle for
Daily Driver
Posted on 08/16/2009 by Doug R. - 2007 Chevy Tahoe (Albion,IL)
1 of 1 people found the following review helpful.

Appearance

Ease of Installation

Price/Value

Quality
"Due to the price, I held off buying the unit for about 12 months. I have now purchased and installed it on my 2007 Tahoe and have already seen an increase in mileage of 2 MPG. The unit looks great and was really easy to install. I took my time and completed it in about 45 minutes. It will pay for itself and it certainly seems to have added HP as well. Great decision to purchase."
Was this review helpful? Yes
No
About Doug R.
Vehicle
2007 Chevy Tahoe
I use my vehicle for
Commuting, family activities, pulling an atv trailer
K&N 77 Series on 03 Grand Cherokee
Posted on 08/15/2009 by Cole S. - 2003 Jeep Grand Cherokee (Glen Allen,VA)
0 of 0 people found the following review helpful.

Appearance

Ease of Installation

Price/Value

Quality
"The intake itself takes 10 minutes to install. The removal of the stock air box was a hassle and took almost an hour and a half to get it out. It took about 30 minutes to get the new heat shield in and it fits pretty snug. On thing I suggest is long, deep dish metric ratchets for this assembly."
Was this review helpful? Yes
No
About Cole S.
Vehicle
2003 Jeep Grand Cherokee
I use my vehicle for
Daily Driver