K&N 63 Series AirCharger High-Flow Intake Kit

just what is asked for

Posted on 12/05/2006 by Ezequiel S. - 2006 Ford F150 (Houston,TX)

0 of 0 people found the following review helpful.

"The instalation was easily done in about 2 hrs. The extra engine roar is nice but not excessive. Overall a nice upgrade."

Was this review helpful? Yes No

2005 Dodge 4.7 Quad Cab Ram

Posted on 12/01/2006 by Douglas H. - 2005 Dodge Ram (Kingsland,GA)

0 of 0 people found the following review helpful.

"Installation instructions were easy to follow. I liked all the pictures. Only real down side is that I had to buy four bolts at a local hardware store that were missing from the kit. The kit sounds awesome and I am getting an extra 2-3.5 mpg. Well worth the cost."

Was this review helpful? Yes No

05 F350 V10

Posted on 11/30/2006 by David P. - 2005 Ford F150 (Oxford,AL)

0 of 0 people found the following review helpful.

"Installation was straight forward, with the only trouble being caused by Ford's placement of a clamp. My truck seems to have a little more oooomph down low and all the way through the rev range. There is no noticable noise until 3/4 to full throttle. I look forward to not buying more air filters and hopefully a little boost in economy."

Was this review helpful? Yes No

K&M Intake for an '06 Chevy Colorado

Posted on 11/29/2006 by Andrew B. - 2006 Chevy Colorado (Rock Hill,SC)

0 of 0 people found the following review helpful.

"First of all I was VERY impressed with shipping. I ordered the intake on the morning of November 14th. I am not lying when I say that it was delivered to my house on November 15th. I did not pay anything extra for shipping, that was just the standard free shipping that was included. A+ on Shipping. I am not too familiar with whats under the hood of my truck or any other auto for that matter but I wanted to put the intake on myself. It was very easy and took me about 2 hours just because I was very careful and kept checking myself. It was very easy. I have only been through one take of gas so far but the MPG already went from 22 to 23. I got 400 miles out of my first full tank for the first time. I can tell the increase in power is there. I love the intake and would recommend it to anyone. Everything is perfect. Shipping was excellent. Thank you AutoAnything!"

Was this review helpful? Yes No

Simplicity

Posted on 11/28/2006 by Richard G. - 2006 Ford Mustang (Port Saint Lucie,FL)

0 of 0 people found the following review helpful.

"The K&N filter purchased was extremely easy to install and took me roughly an hour. Although I have yet to verify the HP gain the difference is noticable."

Was this review helpful? Yes No

K&N 63 review

Posted on 11/27/2006 by Robert H. - 2006 Jeep Commander (Chino,CA)

0 of 0 people found the following review helpful.

"the intake kit is everything it is advertised to be, the problem i had was in the installation. the instructions were not precise, the assembly pictures were small and blurry and 2 steps were left out.........."

Was this review helpful? Yes No

K&N Air Charge on 2006 2500HD Duramax

Posted on 11/25/2006 by George S. - 2006 Chevy Silverado (Hereford,AZ)

0 of 0 people found the following review helpful.

"It was install about two weks ago and I can tell it has improved my MPG by about 7% towing an 10,000 pound HR travel trailes. I will be installing a Banks Monster Exhaust system next week to improve the air output."

Was this review helpful? Yes No

Great

Posted on 11/25/2006 by Joseph J. - 2006 Ford F150 (Warner Robins,GA)

0 of 0 people found the following review helpful.

"This is the first mod for my 06 F150. It definetly adds the power to my truck."

Was this review helpful? Yes No

good product

Posted on 11/24/2006 by Keith A. - 2006 Ford F150 (Sterling Forest,NY)

0 of 0 people found the following review helpful.

"a little more power and better throttle response."

Was this review helpful? Yes No

i like it

Posted on 11/22/2006 by Jamal A. - 2005 Ford F150 (Dahia Abdullah Alsalim,--)

0 of 0 people found the following review helpful.

"before i have k&n 77 [ not good ] no power + noise from the silicone hose 90 degree touching the body. now more power + no noise ."

Was this review helpful? Yes No

easy to install

Posted on 11/22/2006 by Mitch W. - 2005 Dodge Dakota (Rock Creek,OH)

0 of 1 people found the following review helpful.

"fit perfectly on my vehicle but i do not really think it made a big difference in performance or gas milage. overall i am satisfied"

Was this review helpful? Yes No

Intake worth every penny!

Posted on 11/20/2006 by Rodney V. - 2003 BMW 330i (Bronx,NY)

0 of 0 people found the following review helpful.

"I received the kit a few weeks ago but haven't had the time to install. Today I installed the kit and test drove the car. What a blast!! The sound alone will put a smile on any enthusiasts face. The instructions were clear concise and very easy to follow. All parts were accounted for and seem to be made of quality components. The install time was just under two hours taking my time. On the test drive I noticed the hissing sound that I expected when throttle is applied. I was suprised however at the sound achieved when accelerating past 3500 RPM. A very deep rumble coupled with a crisper throttle response. This car pulls very well normally but the boost from the K&N intake kit is noticeable. The dyno sheet received with this kit states an 11.46 horsepower gain with torque increases along the whole driving band. I tend to believe it from the feedback the car gave back. I cannot comment on gas mileage because I haven't driven it enough. Two thumbs way up!!!"

Was this review helpful? Yes No

undecided

Posted on 11/20/2006 by Daniel F. - 2006 GMC Sierra (Norris,TN)

0 of 0 people found the following review helpful.

"I installed the new intake kit on my 6.0 GMC. I have not taken any long trips yet so I am undecided if I will save on gas mileage. Other reports say that I will. I can certainly feel the difference in horse power. Previously I was getting 14.7 MPG around town and now about 13.5. Maybe it's because I am playing with newly found horse power. The only thing that I can't understand is the design of the new bulkhead that blocks engine heat and holds the filter, tube and housing in place. The bulkhead came with a rubber gasket that I thought would seal the intake filter from the engine compartment giving me a true cold air intake. The gasket only touches the hood and part of the finder well. The lower area is wide open to pull heat from the exhause manafold and radiator. I am trying to decide if I should add to the bulkhead so I get cold air like the original system got from the opening in the fender. The instillation was as simple as the reports say it is, less than an hour."

Was this review helpful? Yes No

Great investment, pain to install yourself!

Posted on 11/16/2006 by Jason H. - 2006 Ford F250 (Jackson,WY)

0 of 0 people found the following review helpful.

"This product improved my throttle response and gave me a couple of more miles to the gallon on my ford powerstroke, well worth the money, but the down side the installation instructions were horrible, you pretty much have to be mechanically minded to install yourself! Jason, Wyoming."

Was this review helpful? Yes No

Great Product, good instructions

Posted on 11/16/2006 by Mike G. - 2006 Dodge Ram (Colleyville,TX)

0 of 0 people found the following review helpful.

"Installed on my 2006 Dodge MegaCab 5.7 Hemi. Took about 1.5hrs, the instructions were good. Had a little trouble with removing/installing the temp. sensor, but everything else went smoothly. I have notice quicker throtle response. Recommend."

Was this review helpful? Yes No

05 v10 f250

Posted on 11/16/2006 by Dan B. (Fayette,OH)

0 of 0 people found the following review helpful.

"Was not real happy with the fit and finish.One of the boot conectors was too big. I was missing some nuts and bolts, and 2 hose clamps. I just had to use some clamps from the oem intake and buy a couple of bolts. Have not noticed any difference in power or milage."

Was this review helpful? Yes No

2006 cummins k&n cold air intake

Posted on 11/16/2006 by Dustin B. - 2006 Dodge Ram (Punxsutawney,PA)

0 of 0 people found the following review helpful.

"installation took about 45 minutes from the time i opened the box,noticed a little more power, better trottle response and alot more noise under the hood.Great item"

Was this review helpful? Yes No

K&N For My Canyon

Posted on 11/14/2006 by Scott J. - 2005 GMC Canyon (Hayes,VA)

0 of 0 people found the following review helpful.

"I am very pleased with my K&N and it was easy to install, but an adapter was missing for the fuel vent and I had to go to the hardware store to pick one up. A previous review I read had the same issue, so perform an inventory before you start the process as this seems to be a recurring problem."

Was this review helpful? Yes No

2006 Toyota Tacoma steps it up

Posted on 11/13/2006 by Craig C. - 2006 Toyota Tacoma (Marion,IA)

1 of 1 people found the following review helpful.

"Have recently installed K&N high flow intake kit and am getting used to the growling under the hood. It has additional horsepower and gas mileage has not changed. I do get compliments from passengers in vehicle always wanting me to put my foot into it and make it growl."

Was this review helpful? Yes No

Great

Posted on 11/11/2006 by Matt R. (Higley,AZ)

0 of 0 people found the following review helpful.

"Was easy to install and I am very pleased with the performance."

Was this review helpful? Yes No

K&N 63 Series

Posted on 11/11/2006 by Robert L. - 2006 Ford F-150 (Coopersville,MI)

0 of 0 people found the following review helpful.

"I install it on my 2006 F-150 5.4, it took me about an 1 1/2 hours to install, very good instructions and it looks great on the truck. When I took it for a test drive I couldn't believe how great it sounds, the motor really breaths. The performance is much better, you can tell the difference from a dead stop, and you can really feel the difference when you need to pass someone. Not sure on fuel mileage yet. Combined with flowmaster catbacks I already have on the truck it is AWESOME! Now all I need is a superchips programmer and I'll be set."

Was this review helpful? Yes No

Lefty's GT Aircharger Install

Posted on 11/09/2006 by David W. - 2005 Ford Mustang (Tucson,AZ)

0 of 0 people found the following review helpful.

"The installation of the kit went very smoothly. the only exception was the mass air sensor opening in the intake tube was too small and had to be filed out for the air sensor to fit in. The increase in HP is clearly noticeable especailly at higher rpm's. The slightly louder sound of the engine is nice. Good job K&N on this kit!"

Was this review helpful? Yes No

K & N 63 _F150

Posted on 11/08/2006 by Ray D. - 2008 Dodge Ram (Brookhaven,PA)

0 of 2 people found the following review helpful.

"Just what i was looking for gave my f150 just the extra edge when pulling my trailer (more torque pulling up hills). have not seen any mpg difference though but it is still new to the truck. thanks."

Was this review helpful? Yes No

Not well satisfied for my 06' F-250

Posted on 11/08/2006 by Tracy C. - 2006 Ford F250 (Marbury,AL)

0 of 0 people found the following review helpful.

"The installation was easy but the package was missing 2 nuts and washers. Fuel mileage decreased by 3 mpg and not happy with the exta noise. :("

Was this review helpful? Yes No

2005 GT Mustang

Posted on 11/07/2006 by Greg M. - 2005 Ford Mustang (Cocoa Beach,FL)

0 of 0 people found the following review helpful.

"Instructions were pretty clear - only step missing was the rebreather tube, not mentioned anywhere that I noticed. Normally the car is pretty perky, only noticed a diff under hard acceleration, really took off, to early to tell on mileage. Will be adding one to my expedition w/5.4"

Was this review helpful? Yes No