Jet Power-Flow Mass Air Sensor

Pleased

Posted on 05/22/2008 by Blaine H. - 2003 Chevy Tahoe (St. Alberta,Alberta)

2 of 4 people found the following review helpful.

Appearance

Ease of Installation

Price/Value

Quality

"No issue installing new sensor with new cold air intake. Whole install took less than an hour."

Was this review helpful? Yes No

Ford E350 SD

Posted on 05/16/2008 by Arthur D P. - 2006 Ford Econoline (New Port Richey,FL)

0 of 0 people found the following review helpful.

Appearance

Ease of Installation

Price/Value

Quality

"After installing the Jet Power-mass air sensor in the K&N cold air intake, I could feel the difference in power right away,also my MPG increased.This will help with towing my 35ft RV. With the rising coast of fuel this will pay for it's self in no time at all."

Was this review helpful? Yes No

below expectation

Posted on 05/09/2008 by Mohammad B. - 2008 GMC Sierra (Springfield Gardens,NY)

0 of 0 people found the following review helpful.

Appearance

Ease of Installation

Price/Value

Quality

"changing mass air flow sensors are required for only racers that will need to fool the car computer with fake figures about the intake air. other than that it is not recommended"

Was this review helpful? Yes No

2004 chevy silverado 5.3 4x4

Posted on 04/10/2008 by Dustin V. - 2004 Chevy Silverado (Shreveport,LA)

0 of 0 people found the following review helpful.

Appearance

Ease of Installation

Price/Value

Quality

"it gave me very little power and i havent noticed any mileage increase to speak of but i have a hard time keeping my foot out of it"

Was this review helpful? Yes No

2007 Monte Carlo SS

Posted on 03/27/2008 by David B. - 2007 Chevy Monte Carlo (North Pole,AK)

0 of 0 people found the following review helpful.

Appearance

Ease of Installation

Price/Value

Quality

"Very simple instalation, took about 10 mins. No problems with error codes or check engine lights. Haven't really noticed any gains in fuel economy but seems to have a bit more power"

Was this review helpful? Yes No

Good Product

Posted on 02/09/2008 by Jorge G. - 2006 Chevy Silverado (Saltillo,coahuila)

17 of 18 people found the following review helpful.

"I put the MAF and my time in quarter mile improve by .30 seconds ( silverado 5.3 2006) my time before was 15.50 and now its 15.20, great product highly recomded. very easy instalation took less than 10 minutes."

Was this review helpful? Yes No

Still need to do more testing

Posted on 01/26/2008 by John O. - 1996 Chevy Caprice (Hayward,CA)

2 of 20 people found the following review helpful.

"I install the unit on a Jaguar conversion to using a 96 5.7 Chevy engine. Looks great, easy installation, but due to me being bussy and all the rain we have been geting I have not driven the car much."

Was this review helpful? Yes No

Great Product!!!

Posted on 01/14/2008 by Jorge R. - 2008 GMC Sierra (Miramar,FL)

13 of 16 people found the following review helpful.

"Installed it with a K&N 77 Cold Air Intake and a Jet Stage 1 Chip and saw incredible jumps in power and gas efficiency. Will recomend to everyone, especially with todays gas prices."

Was this review helpful? Yes No

2003 f150 4x4 4.6L

Posted on 01/11/2008 by Richard K. - 2003 Ford F150 (Bellevue,NE)

0 of 0 people found the following review helpful.

"Haven't had it installed for long, but was hoping it would get rid of this "burping" sound after I installed a K&N intake/filter. Thought the stock MAF was to restricted to keep up with the more air coming in, causing the burping at idle after letting off the gas. Thought the price was expensive, but stock MAFs are even more."

Was this review helpful? Yes No

2008 Silverado

Posted on 01/08/2008 by Larry J. - 2008 Chevy Silverado (Martinsburg,WV)

15 of 19 people found the following review helpful.

"I installed the Jet Power-Flow Mass Air Sensor, I noticed a big improvement in air flow right away. Gas mileage improved 2 MPG. I would recommend this product to Anyone that wants a little more horsepower and better gas mileage."

Was this review helpful? Yes No

great

Posted on 12/22/2007 by Steve B. (South San Francisco,CA)

0 of 0 people found the following review helpful.

"it works just as I knew it would!!!! GREAT"

Was this review helpful? Yes No

Jet Power-Flow Mass Air Sensor 2007 avalanche

Posted on 11/28/2007 by Joe Daniel V. - 2007 Chevy Avalanche (Edinburg,TX)

10 of 12 people found the following review helpful.

"awesome product that only took 5 minutes to install-and noticed the immediate horsepower gain as well as slight gas mileage increase-highly recommend"

Was this review helpful? Yes No

Good Quality & Fit

Posted on 11/20/2007 by Joachim S. - 2004 Chevy Silverado (Anchorage,AK)

8 of 11 people found the following review helpful.

"This JET Powr-Flo Mass Air Sensor was just as described. Quality of material is good and fits just as the stock unit. Throtlle seems to be more responsive and getting better airflow as well. Doesn't have the restrictive stock MAF screen. Can't tell if there is any increase in gas mileage since I am doing a lot of in town driving. Overall I am pleased with upgrade."

Was this review helpful? Yes No

MAF Compliments ECM and Cold air Upgrades

Posted on 11/17/2007 by Les M. - 2004 Infiniti FX35 (Acworth,GA)

0 of 0 people found the following review helpful.

"The Jet Powr-Flo was just the ticket to let my Jet ECM add-on and K@N filter setup breath to its full potential. Not only has it given a much need boost to my low and mid range torque, it has helped the computer clean up the factory see-saw shifting algorythm on my 2002 Ford 5.4 Lariat. Installation was 15 minutes with no more than a straight blade screw driver - perfect fit and excellent quality."

Was this review helpful? Yes No

07 Tahoe

Posted on 11/15/2007 by Christopher C. - 2007 Chevy Tahoe (Roselle,IL)

9 of 18 people found the following review helpful.

"I haven't noticed any difference in performance or gas milage. It was a waste of money."

Was this review helpful? Yes No

big differents!

Posted on 11/14/2007 by Mark M. - 2006 Pontiac G6 (Frederickburg,VA)

8 of 14 people found the following review helpful.

"more power for the money,plus better take off response at the light.you well see the BIG DIFFERENTS in your G6.WATCH OUT FOR THA PO-PO!"

Was this review helpful? Yes No

great product

Posted on 10/05/2007 by Charlie M. - 2003 Chevy Silverado (Neptune Beach,FL)

8 of 11 people found the following review helpful.

"it was very easy to install, about 5 minutes. noticable horse power right away."

Was this review helpful? Yes No

Seems Better

Posted on 09/22/2007 by Sterling L. (Austin,TX)

6 of 9 people found the following review helpful.

"I purchased the Jet Power-Flo along with a K&N 77 Series Metal Intake Kit. Installation was very simple except for the two 6mm nuts (on the K&N) that were supplied were not 6mm they were maybe 3mm. I have noticed what seems to be better mid and high end power. Maybe alittle better off the line. But it is a 2004 Silverado with 5.3L so it is not a HotRod to begin with."

Was this review helpful? Yes No

Something new...

Posted on 09/18/2007 by Randell S. - 2001 Ford Expedition (Jacksonville,FL)

0 of 0 people found the following review helpful.

"I orderd this product to be used with a cold air intake and a throttle body spacer. It doenst look like the picture which was great. It was better. All the parts were simple to install and the end results were HOT! The top end is a huge distance from the original equipment."

Was this review helpful? Yes No

best for ever

Posted on 09/13/2007 by Khalid Abdulla A. - 2002 Chevy Tahoe (Springfield Gardens,NY)

0 of 1 people found the following review helpful.

"the Jet Power-Flow Mass Air Sensor the best in my truck"

Was this review helpful? Yes No

jet mass air flow

Posted on 09/06/2007 by Adam S. - 2003 Ford Expedition (Warrenton,VA)

0 of 0 people found the following review helpful.

"I installed an airade cold intake and magnaflow exhaust on my 03 ford expediton and the performance was excellent!! I then added the jet mass air sensor and what a difference!! I am very happy with these products, and auto anything... Thanks!!!"

Was this review helpful? Yes No

mass flow sensor 97 gmc

Posted on 09/01/2007 by Earl S. - 1997 GMC Truck 1500 (Kentwood,MI)

0 of 0 people found the following review helpful.

"very easy to install havent felt a diffence but good product."

Was this review helpful? Yes No

MORE POWER

Posted on 08/02/2007 by Archie G. - 2006 Buick LaCrosse (Chesapeake,VA)

0 of 0 people found the following review helpful.

"Installed in my '06 Lacrosse. Accelerates better than when new. Also have cold air intake. Highly reccomended."

Was this review helpful? Yes No

Worth the $$

Posted on 07/20/2007 by David M. - 2007 GMC Sierra (Keller,TX)

1 of 1 people found the following review helpful.

"Decent bhp gains. No actual numbers to report but substantial power gains across the mid-range power band, especially in the upper rpm range. No "noticable" increase in the lower torque range but definitely worth the $$. 2007 Sierra Denali - 6.2L"

Was this review helpful? Yes No

Let the air flow!!!!

Posted on 07/16/2007 by Andy M. - 2007 Chevy Silverado (Janesville,WI)

1 of 1 people found the following review helpful.

"It really has helped with the air flow, but I have yet to see anywhere near the fuel mileage gains much of the reivews stated- what are you guys doing to achieve 3+ mpg's? Perhaps my '07 5.3 is just plain thirsty.:) Otherwise, the installation was a snap, intstructions were ok, and I had it up and running within minutes. It took longer to disconnect the GM Performance air tube (GM Perforance Intake kit is a great addition also; fits perfectly and looks great with the chrome top plate.)to allow access to the sensor."

Was this review helpful? Yes No