Reviewed By Eric C (SHIPPENSBURG, PA) Reviewed for a 2014 Ford F-150 —1/18/2018 3:31 PM
K&N cold air intake was easy to install and was quick bolt on horsepower.
Reviewed By Gary E (MEDFORD, OR) Reviewed for a 2014 Ford F-150 —11/18/2017 7:49 AM
As always, K&N products are quality built. The air tube is powdercoated aluminum. Took about an hour to remove the factory parts on the Raptor SVT and install the K&N kit. The only issue is the bolts to fasten the airbox and coolent tank to the truck body are a bit short, so difficult to get started in the threaded holes. 1/4" longer bolts would make it easier. I did not notice an increase in engine noise over stock with this installation
Reviewed By John H (Plano, TX) Reviewed for a 2014 Ford F-150 —10/5/2017 9:05 PM
Once you figure out the set up which is easier than trying to follow the instructions the install is reasonable. My kit was missing a machine metric fine thread screw to hold the sensor so once I located from my personal hardware, the job was completed. You can not beat the price, and the product works wonderful. The components fit tightly with little room to spare. So be prepared to do some compression while righting the clamps. Auto anything delivered as promised.