Your Cart Is Empty

1995 Jeep Cherokee Cold Air Intakes

Have a Question?
Have a Question? Ask a product expert! (800) 874-8888 Live Chat

  • shipping icon
  • Not Rated Yet

 

View all reviews for this product

There are no customer reviews for this product

You may only compare up to 5 products at a time.
Please select at least two products to start comparing.

Latest Customer Reviews

Airaid Intake System Reviews


DFK

Reviewed By D.F K (Bayfield, CO) Reviewed for a 1995 Jeep Cherokee —4/11/2013 8:09 AM

Performs as hoped for and expected, notable throttle response. However, everything considered, I feel the price was excessive. Materials and being mass produced does not justify the price.

View More Reviews

K&N 57 Series FIPK Air Intake (50-State Legal) Reviews


K&N cold air kit for Expedition 4.6

Reviewed By William A (Beaumont, TX) Reviewed for a 1995 Jeep Cherokee —6/13/2007 7:36 PM

This kit works really good. It installed in about two and a half hours taking my time cleaning stuff and fixing a couple of little problems along the way. Oh yeah, and most of the work was done after dark with a flashlight. Everything worked out as advertised except that the vacuum line fittings located near the factory throttle body on the cold air tube are located about 1" further forward than originally. The fix was to adjust the 5/8" factory vacuum line a little on the factory end at the nipple and it was then long enough to reach. Then the 3/4" vacuum line was fit-up as follows. The 3/4" vacuum line has a 90 degree factory plastic vacuum pot that had to have its nipple trimmed down first on the new cold air kit side of the 90 degree fitting. I just hacksawed off, very carefully, part of that nipple just behind the vacuum hose stop using the back of the stop as a guide. This left enough of the plastic nipple for the hose and allowed the fitting to rest where it could connect in place to the cold air kit nipple in a more straight lined up fashion. I used the extra 5/8" vacuum hose supplied in the kit for the 5.4 liter engine and cut approximately 1 1/4" off one end of the hose. This short 1 1/4" piece went to the cold air kit side of the vacuum pot and the remainder of the hose went to the factory nipple side. The 5/8" hose fit really good with a little manipulation and spit. This allowed room for the factory engine cover bracket to be refitted without any clearance issues. Also before beginning the work I had to go to the parts store to get the big clamp that holds the air filter on since someone else had already been digging in the box but that's no great big deal. Just take your time and round up all your parts first before beginning and it will be simple. Other than these two issues everything worked out smoothly but you have to remember that the manufacturer can't cover every contingent. I noticed later that the illustration in the instructions supplied by K&N d

View More Reviews

Volant Cold Air Intakes Reviews


Sickkkk

Reviewed By frances m (RUSSELLVILLE, AR) Reviewed for a 1999 Jeep Cherokee —10/6/2014 8:40 PM

Ordered on Sunday night. Recieved Tuesday morning. Installation was very straight forward. Jeep sounds like a beast with it! Engine doesn't have to work near as hard, idles easier, and throttle response is insane! BE AWARE: the two bolts on the stock intake are double threaded. Love autoanything's service and will definitely be buying from here again!

View More Reviews