Took some imagination...
Reviewed By William B (Snohomish, WA) Reviewed for a
—12/9/2009 4:18 PM
I found that the instructions could have used more detail in the photos. It was hard to tell what some of the pictures where showing. Had to cut the tube between the crankcase breather and the intake. Not a big deal, but the instructions didn't mention it. Also there was no hose clamp included to secure the crankcase vent hose to the intake. Hose clamps on the throttle body were a bit large, so there is a lot of extra sticking out. I guess I could cut it off. Tightening the hose clamp that holds the filter to the intake was a challenge. I used a socket wrench and was able to get it tight. Hope I don't have to remove/replace it anytime soon. I didn't like how you are forced to remove the wiring harness from the supports and pull it forward. Would have been better if they supplied an extension for the sensor wiring. Not sure what others do to get around this, but I expected more from K&N.