Reviewed By Joe C (HOWELL, NJ) Reviewed for a 2010 Toyota Tacoma —7/26/2016 9:46 PM
This piece was easy to install and works fine.
Reviewed By Eric G (HIGHLANDS RANCH, CO) Reviewed for a 2014 Toyota Tundra —4/25/2016 6:48 AM
I'll say this..it's relatively inexpensive and very easy to install. I did this at the same time as installing my Jet mass airflow sensor. Low end is definitely better. I'm not sure if this does much based on other's feedback.
Reviewed By Christopher W (STUART, FL) Reviewed for a 2008 Toyota Tacoma —1/18/2016 3:53 PM
I purchased the Poweraid TB spacer for my 2008 Toyota Tacoma 4.0 V6. The install was easy but lacked good illustrations in the instructions. I was unable to put the engine beauty cover back on due to the bolt holes not lining up very well. I can hear the whistle at part throttle with my K&N drop in air filter but it's kind of cool. I could barely hear it with the stock filter. I can't tell if it added any MPGs or torque to my truck but I like knowing its there. Looks good under the hood.