Reviewed By Christopher T (MATTHEWS, NC) Reviewed for a 2008 Toyota 4Runner —8/25/2015 4:52 AM
Great sound and performance from intake cleans up engine bay substantially
Reviewed By Alan P (Birmingham, AL) Reviewed for a 2000 Toyota 4Runner —2/2/2016 4:34 PM
Installation went well with a few exceptions. First, the heat shield is too tall for the 2000 4Runner. Leaving one screw attached I lowered the shield to allow the hood to fasten down. It is loose but the lowered hood keeps it from moving. Second, the shoulder bolts on the band clamps bottomed out before they tightened down securely. I will have to buy full thread bolts to secure the air tube to the intake manifold. Performance seems to have increased a bit after a few days.
Reviewed By hal b (SAINT PAUL, MN) Reviewed for a 2015 Toyota 4Runner —11/17/2015 7:04 AM
Install was pretty easy. A couple things....I had to re-drill the mounting holes a little bit as they didn't match up perfectly. Also, the MAF sensor kept giving me "trac off" code. I had to use light lock-tite to make sure it didn't loosen up. Sound is good but not super impressive, I'm going to add exhaust next. Acceleration is improved as well as my mileage (up almost 1 mpg at this time already!). I drive 35,000 miles a year so this will pay for itself in no-time!