Your Cart Is Empty

2010 Toyota Sequoia K&N Air Intake Systems

Have a Question?
Have a Question? Ask a product expert! (800) 874-8888 Live Chat

  • shipping icon
  • Not Rated Yet

 

View all reviews for this product

There are no customer reviews for this product

You may only compare up to 5 products at a time.
Please select at least two products to start comparing.

Latest Customer Reviews

K&N 63 Series AirCharger High-Flow Intake Kit Reviews


63-9031-1 for 2010 Toyota Sequoia 5.7L

Reviewed By Lawrence H (SANFORD, FL) Reviewed for a 2010 Toyota Sequoia —2/14/2013 3:27 PM

First off, a big shout out to AutoAnything for great prices and super fast shipping! Secondly, I want to warn others that K&N's directions are horrible. In fact the parts diagram is for another intake so it adds to the confusion when installing. Be prepared to SLOWLY go through them. I would recommend a mock-up of the intake before even opening the hood. It will save you from some frustration So far I'm really liking the intake though - great sound and look.

View More Reviews

K&N 57 Series FIPK Air Intake (50-State Legal) Reviews


Sounds Great

Reviewed By Jason W (OVERLAND PARK, KS) Reviewed for a 2005 Toyota Sequoia —6/19/2014 10:36 PM

The install on my Sequoia V8 went really smooth, took me about 2 hours but I did it slow and cleaned my MAF before firing it up. Just sounds like a lot of air at idle and lower RPM range but really growls above the 2,800 mark and roars above the 3,600 mark. I did notice a 1-2 mpg improvement at highway speeds, but that could just have been from cleaning the MAF sensor, not a whole lot in the lower cruising rpm range but the acceleration is noticeably better especially above the 3,000 mark

View More Reviews

K&N 77 Series Metal Intake Kit Reviews


Quality Product & Easy Install

Reviewed By Gary E (MEDFORD, OR) Reviewed for a 2014 Ford F-150 —11/18/2017 7:49 AM

As always, K&N products are quality built. The air tube is powdercoated aluminum. Took about an hour to remove the factory parts on the Raptor SVT and install the K&N kit. The only issue is the bolts to fasten the airbox and coolent tank to the truck body are a bit short, so difficult to get started in the threaded holes. 1/4" longer bolts would make it easier. I did not notice an increase in engine noise over stock with this installation

View More Reviews