Reviewed By Gene G (COMMACK, NY) Reviewed for a 2012 Hyundai Veloster —5/16/2014 11:42 AM
Securing the heat shield to the front support bar with that tiny screw was very difficult. Finally gave up & used a longer screw through the front with a washer. Why such a small screw? Also-why couldn't the rubber trim for the heat shield come already pre-cut into 8" & 20"strips? Was a little tight getting the intake tube installed. Slight increase in power & nice little growl when accelerating.
Design and look is great
Reviewed By Edna D (KENNESAW, GA) Reviewed for a 2013 Hyundai Veloster —10/18/2013 8:50 PM
But once received the quality of the piping is cheap and thin and no different than the $20 eBay ones . Style and paint job is nice , heat shield design was very sleek but piping was a disgrace . Upon ligt clamp pressure for the couplers he piping bends and dents and has no roll beaded edges to help keep couplers and filter from sliding off so easy . My previous Injen intake was the highest and thickest quality of piping I ever used and I would use them again over k&n next time!