62 MM throttle body
Reviewed By Larry F (Robesonia, PA) Reviewed for a 2008 Ford Mustang —4/10/2015 6:44 AM
Installed on 2008 Mustang Bullitt. Only other Mods have been BBK under drive pulley set and axle back flow masters. Signifcant increase in throttle response - engine could not run any more smoothly - a quality built product. Installation rather straight forward - no retune required. Slight increase in throaty exhaust note! Performance that is well worth the investment. Highly recommend!! Thank you Auto Anything and BBK. Larry Reading, Pa.
2007 Chevrolet Silverado Z71 Throttle Body Review
Reviewed By Joshua M (DOUGLASSVILLE, TX) Reviewed for a 2007 Chevy Silverado —4/1/2015 7:53 AM
This item was backordered, so it took a little while to ship to me, however it was very easy to install, just remove the cold air intake hose clamp, take out four bolts, and unplug, Do Not Forget to unplug the battery like i did, or the throttle body will not reprogram to your vehicles computer. I did not see much throttle response on take off, but at high speeds you can tell a difference....Ex. from 70-100 mph. Autoanything.com's price was the best one i found on the internet, All in all i was pleased with the product, but be prepared to have high throttle for the first 100 miles after installing, after that my truck runs good and i am happy with my bolt on mod. I would reccomend buying.
Be patient, the PCM will eventually figure it out! Well worth it
Reviewed By Adrian L (Boise, ID) Reviewed for a 2006 Dodge Magnum —4/8/2015 9:13 AM
I have one of these TB's on another of my modified Hemi vehicles. It eventually worked so well that I added one to my other modified Hemi vehicle. Easy install but getting it to play well with the PCM is not. Same problem with the first one too, but it finally came around. It'll take as long as about 50 good run cycles for the PCM to figure out what's going on. You may encounter idle DTC codes (don't reset them yet), surging, hunting RPM, stalling, etc. Once done, it works fantastic. Be patient.