Reviewed By Gregory L (Apex, NC) Reviewed for a 1991 Chevy Corvette —8/17/2006 4:25 PM
I have a '91 Vette and needed replacement rotors and pads. The SSBC kit came complete with everything I needed for a complete 4 wheel brake overhaul (except brake lines and master cylinder) I was expecting so-so pads but found out that SSBC packages Hawk HP pads. Sweet! The rotor are pre-manufactured by WearEver and then SSBC CNCs the slots into them. This gave me a new level of confidence knowing that the rotor were trued by WearEver and then during SSBC'c quality process trued again when the slots were added. As far as value, I saved over $60 using the kit versus buying everything seperately and that's with standard rotors instead of slotted. After installation, the car's braking was a night and day difference. Smooth as butter and the rotors are very true. The rotors are very thick and with new pads you will need to make sure caliper pistons are fully pressed in when installing. The only complaint I have is that SSBC did not label which rotors were for front or back which is kind of hard since a vette's rotors are both 12" dia. in front and back. With lots of comparison I finally figured it out. AutoAnything is awesome! I got free shipping on an 80lb order and the kit arrived in 3 days. Thanks AuthoAnything!