Your Cart Is Empty

Toyota StopTech Brakes, Rotors & Pads

Have a Question?
Have a Question? Ask a product expert! (800) 874-8888 Live Chat

  • shipping icon
  • Not Rated Yet

 

View all reviews for this product

There are no customer reviews for this product

You may only compare up to 5 products at a time.
Please select at least two products to start comparing.

Latest Customer Reviews

StopTech Slotted Brake Rotors Reviews


StopTech Slotted Brake Rotors

Reviewed By Antonio P (CHEWELAH, WA) Reviewed for a 2003 Toyota Tundra —7/5/2017 2:34 PM

Paired these rotors with Hawk LTS pads and installed them on my 2003 Toyota Tundra. Took the opportunity to bleed the brake system using the second method shown in this video https://www.youtube.com/watch?v=n1NvtUwfRJc (not my video). These are of much higher quality than the brake components that I pulled off. These brakes bite way harder. Before installation be sure to wipe them clean by spraying a generous amount of brake clean and wipe both sides until they wipe clean.

View More Reviews

StopTech Drilled & Slotted Street Brake Kit Reviews


2011 Toyota Sienna SE stoptech drill/slot w/ ceramic pads

Reviewed By Daniel X (SACRAMENTO, CA) Reviewed for a 2011 Toyota Sienna —6/22/2017 9:02 PM

Products came in fast, easy to install and most important car does stop faster than oem. As soon as you step on the brake pedal like a usual step on oem rotors, you can feel how fast the car is stopping. I would say a gap between 20ft further off from oem. I would recommend this to any Sienna owner out there if you are interest in upgrading your rotors.

View More Reviews

StopTech Stainless Steel Brake Line Kit Reviews


Braided Stainless Steel line for 2005 Toyota Tacoma 2WD

Reviewed By Timothy B (College Station, TX) Reviewed for a 2005 Toyota Tacoma —5/11/2017 2:28 PM

I bought both the front brake lines (95044007) and the rear brake lines (95044520)for my 2005 Toyota Tacoma. The front lines installed without a hitch. The rear lines took a little work. The fittings didn't quite match up with the factory brackets. I had to use a Dremel tool and file to enlarge the bracket holes. Strangely enough a couple of the hose ends fit fine and required no modification to the brackets.There is a bracket on the right driver's side frame and a bracket on the axle - if you

View More Reviews