Installed and now hood won't close.
I installed this exaxtly as per the ibstructions and the hood did not close properly because the plastic hood shield and the factory rubber along edge made it too thick to latch unless you really slammed the hood down. At that point the hood was a good quarter inch off in alignment at the front.
Two person job
I discovered that I couldn't screw into the pop-ins and hold the shield in place by myself as the pop-ins started to spin and came out of the hole they had been in. The end clips were extremely difficult to slide onto the edge of the hood. I had to get a small mallet to hammer them on which made me concerned about scratching the paint on my brand new truck. Finally the fit of the shield forces you to have to slam the hood extremely hard in order to close it, which I read in other reviews.