Sort By
Posted on 11/27/2006 by Brad S. (Franklin,OH)
1 of 1 people found the following review helpful.
"These headers really helped wake up the bottom end of my truck. Construction and finish are excellent. These are probably the best header out there for a 4x4 truck that needs all the low end torque they can get. The 310Y is a long tube headers and gives you the best power band, better than the newer midlength model."
Was this review helpful? Yes
No
Posted on 11/26/2006 by Travis H. (Snohomish,WA)
1 of 1 people found the following review helpful.
"instalation was a bitch, drive line doesnt fit back on without any costomizing on a 1978 f250 with a 460 but other than that they look and sound great"
Was this review helpful? Yes
No
Posted on 10/31/2006 by Richard P. (Foster City,CA)
1 of 1 people found the following review helpful.
"VERY NOTICEABLE INCREASE IN HP & PERFORMANCE. A GREAT PURCHASE."
Was this review helpful? Yes
No
great way to wake up a sleeping bear
Posted on 10/20/2006 by Paul J. S. (Sandusky,OH)
1 of 1 people found the following review helpful.
"Easy installation,good quality parts, look great. The idle quality is greatly improved,more low end throttle response,increased fuel economy. And the best id the GREAT SOUND! Deeper more defined rumble without a drone at speed that will drive you nuts!"
Was this review helpful? Yes
No
Posted on 10/17/2006 by Chris C. (Elmendorf Afb,AK)
1 of 1 people found the following review helpful.
"Great product, increased power, acceleration, and fuel economy"
Was this review helpful? Yes
No
Grandma could do it, that easy.
Posted on 09/01/2006 by Carolyn F. B. - 2007 Dodge Ram (Norfolk,VA)
0 of 0 people found the following review helpful.
"very easy install, great looks and perfomance gains"
Was this review helpful? Yes
No
About Carolyn F. B.
Vehicle
2007 Dodge Ram
I use my vehicle for
Everything
Posted on 07/21/2006 by Brennen C. (Port Coquitlam,BC)
0 of 1 people found the following review helpful.
"Awesome"
Was this review helpful? Yes
No
Posted on 07/20/2006 by Michael C. (University Place,WA)
1 of 1 people found the following review helpful.
"Perect fit. Looks great a they preform excellent!!
Nothing but great comments from people. Can,t beat the price, quality or free fast shipping!"
Was this review helpful? Yes
No
Posted on 05/19/2006 by Carlos C. (Hamilton,OH)
1 of 1 people found the following review helpful.
"easy to install,good performance horsepower..i really join"
Was this review helpful? Yes
No
Posted on 04/19/2006 by Anthony C. (San Antonio,TX)
1 of 1 people found the following review helpful.
"This is my 2nd set of these, the quality, fit and finish is top notch. Definately one of the best headers for the 5.7 Vortec, if not the best. Recommended to buy copper gaskets and use lock washers instead of the washers that come supplied."
Was this review helpful? Yes
No
94 Chevy K1500 ,6in lifted, Thorley headers TriY
Posted on 03/29/2006 by Mark A. (San Diego,CA)
1 of 1 people found the following review helpful.
"Simply put AWESOME.
First of all the craftsmanship on the header itself was high quality. Welds were top notch.
All 3 parts: 2 headers and a tri-y connector pipe bolted up perfectly (except I had to cut about 2 inches of of the driver side "U" pipe to clear the extra suport bar for the 6inch RCD lift kit). Other than that one fabrication issue, the system when on great with plenty of clearence to all other engine parts.
I run a Bullet high flow cat back with Thorey headers and it sounds deep and sweet. I definetly notice a few heads turn now when I am at the gas station.
As for performance: the increased torque is huge, made a big difference. I got more roll back and much better throttle response. Gas mileage is to be determined. I just filled up and so far so good. No number to report just yet.
I researched headers for a year before going with thorley and I completely satisfied with my decision."
Was this review helpful? Yes
No
Thorley headers Dodge Powerwagon
Posted on 02/07/2006 by Larry G. (Payson,AZ)
1 of 1 people found the following review helpful.
"These headers were relatively easy to install but the right output nad to have a special exhaust piece hand made to clear part of the cross member. They gave a noticeable increase in low end power and response. More than worth the bit of extra work to clear the crossmember angle brace."
Was this review helpful? Yes
No
Posted on 01/30/2006 by Glenn G. (Lewiston,ID)
2 of 2 people found the following review helpful.
"These are by far the heaviest headers I have ever seen. The quality is superb and they look like they should last forever. The crossover pipe is included and equal quality as well as the gaskets. Not the tin pipes I'm used to seeing."
Was this review helpful? Yes
No
Showing
26 - 38 of
38 Customer Reviews
Go to page
1
2
Previous