We’re sorry. The information you have requested is temporarily unavailable.
Borla Exhaust Systems Part #140317 Customer Reviews
2 Customer Reviews
Reviewed by Peter R (Newtown, CT) Reviewed for a 2010 Volkswagen Jetta — Sep 01, 2010 6:03 AM
Exhaust was not fir correctly, turns out that on 2010's there was a change to the suspension member and because of this the pipe sits on the frame or very near with barely 1/8" clearance, so exhaust is vibrating in forward and reverse. Contacted Borla, they say they are aware of the issue on 2010's but there is soo much room, if they bent the pipe straighter it would have cleared with no problems.....
Reviewed by Robert B (West Saint Paul, MN) Reviewed for a 2009 Volkswagen Jetta — Mar 30, 2010 4:19 PM
Clearance over the suspension supports is limited and the rear piece barely clears. It would seem the location could of been better centered with some different bend angles. One tip when installing the first primary pipe - attach both rubber hangers (near the front) and tighten the stock clamp before attaching the rubber hanger near the rear wheel. The single hanger will want to twist the pipe and not allow for any clearance over the suspension support. All pipe hangers should be level or parallel to the ground. This exhaust will be barely noticeable in increased sound level with the Turbo Diesel.
Ships Between 8/03 - 8/07
- What Do You Drive?
- borla stainless header
- borla dual square intercooled exhaust tip
- borla shorty headers #17258
- impreza 2006-2007 cat-backâ, exhaust part
- ford diesel exhaust kits
- cat back magnaflow exhaust for land rover lr3 review
- datsun exhaust system canada
- dodge neon 98 catalytic converter high flow direct fit
- exhaust for 2004 mazda rx8
- 2003 gmc envoy exhaust
- aries bar one-piece grill guard jeep 2012
- motor oil and filter kit
- windshield wind deflector 2012 civic