Reviewed By gary m (holbrook, NE) Reviewed for a 1972 Chevy C/K Pickup —4/27/2016 12:20 AM
I like headers and hooker makes the best for the money.
Reviewed By Justin E (Yuma, AZ) Reviewed for a 1963 Chevy Chevy II —4/7/2016 9:29 AM
63 Chevy II, Chassisworks clip, LS1, T56 tranny. I did not use the supplied motor mount adapter plates. The quality seemed good. I did spend a little time to deburr the holes and used a file to break the sharp edges. On my car the fit was good with the exception of the driver side O2 sensor. It would not work in the spot designated for it as it interfered with my stock floor pan. I ended up putting a plug in the bung and welding a new bung just downstream of the header. Satisfied overall.
Reviewed By Todd C (FOREST LAKE, MN) Reviewed for a 2012 Dodge Ram —7/29/2016 8:20 PM
I am very happy with these headers! They are built very well. I have aftermarket SOLO Performance Mach 44 cat back exhaust and they have made the exhaust sound even better than it did previously. I installed myself and would say it wasn't too difficult, maybe took 4-5 hours total to install by myself. Note: I did not have to remove the dipstick tube or steering column on the drivers side. The header easily lifted in from below without any issues.