Your Cart Is Empty
 

Honda Ridgeline Borla Performance Industries Diesel Exhaust Systems

Have a Question?
Have a Question? Ask a product expert! (800) 874-8888 Live Chat
2 3 4 5 >

  • shipping icon
  • Not Rated Yet

 

View all reviews for this product

There are no customer reviews for this product

You may only compare up to 5 products at a time.
Please select at least two products to start comparing.
2 3 4 5 >

Latest Customer Reviews

Borla Exhaust Systems Reviews


Mellow sounding exhaust

Reviewed By Hilary S (San Antonio, TX) Reviewed for a 2010 Honda Ridgeline —7/19/2017 11:01 AM

I have had my exhaust installed for a few days so far. Outside of the nice exhaust note I have not had enough miles on it to give a performance review. It took me about 1.25-1.50 hours to install it. The hardest part was getting the nuts off the catalytic converter. I sprayed them with a penetrating fluid several times and let them set over night before they broke loose. Everything fit very well. The oblong exhaust tip looks great.

View More Reviews

Flowmaster Exhaust Systems Reviews


Well worth the money!

Reviewed By Tyler M (HICKMAN, NE) Reviewed for a 2006 Honda Ridgeline —4/24/2017 4:31 PM

No doubt this is the best sounding exhaust system available for the Honda Ridgeline. I was happily surprised to hear that the exhaust system sounds identical to the promo clips on YouTube. The system looks great, especially the dual tips, and was a breeze to install. Going down the road, the kit gives off a very comfortable tone in the cab. It is not too quite nor too loud. I would definitely recommend this product to anyone looking to give their ridgeline that just right tone.

View More Reviews

Magnaflow Exhaust Systems Reviews


Rather have a muffler shop do it!!

Reviewed By Peter B (FORT LAUDERDALE, FL) Reviewed for a 2013 Honda Ridgeline —12/25/2015 7:44 AM

After working under my truck for 2 hours I put the original exhaust back on and took the Magnaflow to the muffler shop. This cost me an additional $150 to fit. The muffler shop had to cut the stainless steel flange off the Magnaflow exhaust. (It was just too small) Then cut the flange off the original exhaust and weld it to the Magneflow. They also had to heat the last muffler support with a cutting torch to bend it in place to prevent it from rubbing on the body work. So unless you have all the

View More Reviews