Your Cart Is Empty
 

Honda Ridgeline Magnaflow Performance Exhaust Systems

Have a Question?
Have a Question? Ask a product expert! (800) 874-8888 Live Chat
2 3 4 5 >

  • shipping icon
  • Not Rated Yet

 

View all reviews for this product

There are no customer reviews for this product

You may only compare up to 5 products at a time.
Please select at least two products to start comparing.
2 3 4 5 >

Latest Customer Reviews

Flowmaster Exhaust Systems Reviews


Well worth the money!

Reviewed By Tyler M (HICKMAN, NE) Reviewed for a 2006 Honda Ridgeline —4/24/2017 4:31 PM

No doubt this is the best sounding exhaust system available for the Honda Ridgeline. I was happily surprised to hear that the exhaust system sounds identical to the promo clips on YouTube. The system looks great, especially the dual tips, and was a breeze to install. Going down the road, the kit gives off a very comfortable tone in the cab. It is not too quite nor too loud. I would definitely recommend this product to anyone looking to give their ridgeline that just right tone.

View More Reviews

Borla Exhaust Systems Reviews


Borla Exhaust

Reviewed By Anthony L (TARPON SPRINGS, FL) Reviewed for a 2007 Honda Ridgeline —3/28/2016 6:28 PM

This system was very easy to install it came with everything needed, and The instructions were on point. I did not even have to lift or jack up the vehicle. I did the complete install while lying om my garage floor. the entire job took less than 90 minutes and I am 60 years old. It looks great, you really can't hear a difference unless you get on it then you hear and feel the difference.

View More Reviews

Magnaflow Exhaust Systems Reviews


Rather have a muffler shop do it!!

Reviewed By Peter B (FORT LAUDERDALE, FL) Reviewed for a 2013 Honda Ridgeline —12/25/2015 7:44 AM

After working under my truck for 2 hours I put the original exhaust back on and took the Magnaflow to the muffler shop. This cost me an additional $150 to fit. The muffler shop had to cut the stainless steel flange off the Magnaflow exhaust. (It was just too small) Then cut the flange off the original exhaust and weld it to the Magneflow. They also had to heat the last muffler support with a cutting torch to bend it in place to prevent it from rubbing on the body work. So unless you have all the

View More Reviews