Your Cart Is Empty
 

Subaru Impreza Magnaflow Diesel Exhaust Systems

Have a Question?
Have a Question? Ask a product expert! (800) 874-8888 Live Chat
2 3 4 5 >

  • shipping icon
  • Not Rated Yet

 

View all reviews for this product

There are no customer reviews for this product

You may only compare up to 5 products at a time.
Please select at least two products to start comparing.
2 3 4 5 >

Latest Customer Reviews

PaceSetter Direct-Fit Catalytic Converters - 49 State Legal Reviews


Good fit (not great)...lets see how durable over time...

Reviewed By Jason E (Wharton, NJ) Reviewed for a 2008 Subaru Impreza —10/7/2015 10:29 AM

direct fit converter fit good. my only complaint is the front O2 sensor isn't angled out enough towards the front resulting in a very tight fit with very little clearance to the timing belt cover. also the O2 bungs for the front O2 sensor for early and late model fitment are welded to close together resulted in trimming the heat sheild for the O2 sensor to be able to screw in to the exhaust. The only thing left is to see is how durable the SS pipes & welds hold up.

View More Reviews

Borla Exhaust Systems Reviews


Borla for 2012 Impreza Sport Prmium

Reviewed By Gordon L (Columbus, OH) Reviewed for a 2012 Subaru Impreza —1/23/2015 6:23 AM

It took about an hour to remove the OEM muffler and install Borla. Very easy to do since the bolts were not that rusty. After installation, I realise that there is more room in the muffler slot. Borla's SS muffler is much smaller than OEM one. The extra elbow room actually helped me when I replaced the OEM 16mm rear sway bar with a STI 19mm one a week later. The exhaust notes from the Borla are louder but not too loud that would wake up the neighbors. Ilike that. I will definitely recommend it.

View More Reviews

Magnaflow Catalytic Converters - 49 State Legal Reviews


Magnaflow Catalytic Converters - 49 State Legal

Reviewed By Mike F (Coupland, TX) Reviewed for a 2003 Subaru Impreza —7/8/2014 7:43 AM

Converter did not fit right. It was about 1.5 inches shorter than the factory one and I had to bend the supports to clear the frame. The angles were also off a little which made it hard to line up. The donut gasket for the rear did not fit the converter tube and had to be ground out for fitting.

View More Reviews