We’re sorry. The information you have requested is temporarily unavailable.
Bushwacker Pocket Style Fender Flares Part #70908-02 Customer Reviews
16 Customer Reviews
Reviewed by Robert D (Oak Harbor, WA) Reviewed for a 2006 Nissan Titan — Mar 10, 2017 3:25 AM
The flares seem durable and they look great on my 06 titan. The hardware included to install flares on truck, suck. I bought higher quality hex head screws to install. I had to drill pilot holes as the pre-drilled holes on flares did not match existing holes on truck. One flare was slightly warped which causes the front 9 inches or so of the flare to not fit flush on the truck. When spending near 500 I think the included hardware should be higher quality.
Reviewed by Tommy P (SIX MILE, SC) Reviewed for a 2014 Nissan Titan — Jan 04, 2016 5:14 PM
These fender flares look great and are easy to install. The only thing i don't like is you have to remove any factory mudguards-flaps. Since installing I have noticed my truck gets dirtier without mud flaps. Tires sling dirt and mud all over sides of my truck now.
Reviewed by Daniel Z (DOLGEVILLE, NY) Reviewed for a 2014 Nissan Titan — Jul 21, 2015 5:09 AM
The flares look great. The driver side flare did not seal very good. The instructions were fair, but they had me remove vehicle screws for no reason.
Reviewed by Linda J (OKEECHOBEE, FL) Reviewed for a 2004 Nissan Titan — Mar 26, 2015 4:44 AM
These fender flares turned my truck into a thing of beautY! Just as a tip, it is sooo much easier to put the seal on the flares BEFORE installation!
Reviewed by LARRY C (Lubbock, TX) Reviewed for a 2016 Jeep Wrangler — Sep 03, 2013 11:50 AM
My wife and I got them installed on my 2012 Nissan Titan in about two hours, tops. If you read the instructions first and don't get ahead of yourself, they are pretty simple to install. We read others complaints about installation, but obviously they did not read the instructions. No drilling of modifying of your vehicle required in any way. The only drilling we did was in the pre-marked divots in the fender flares (rear only). They look like they were custom made for the vehicle.
Reviewed by joe s (JAY, OK) Reviewed for a 2012 Nissan Titan — May 28, 2013 5:44 AM
instructions said needed a 5/16 drill bit but didnt n know where to drill so i drilled into lip of fender on truck and messed it all up . but ends up flares were already pre-drilled. Anyhow there on and had to trim on front flares due to over sized tires
- Rebates: $75 Details
Ships Between 5/26 - 5/31
- What Do You Drive?
- Color:Smooth Black
- Part #:70908-02
- 2" Front Fender Flare Coverage, 2" Rear Fender Flare Coverage
- Fender flare coverage is the distance your Pocket Style Fender Flares extend from the top center of the wheel well out
- Installation difficulty level: Easy
- Installation Instructions (PDF)
- Vehicle cutting not required
- Vehicle drilling not required
- cheapest bushwacker flares
- 88 chevy 1500 fender
- bushwacker 50009-11
- ford f250 wheel flairs
- dog mats cargo liner dodge
- stainless steel wheel well trim
- 2011 chevy 2500hd fender flares
- factory ford fender flares
- fender flares 1987 toyota pickup
- roof rack storage
- truck custom floor mats
- tunnel covers