Projektorz Headlight Covers Customer Reviews
53 Customer Reviews
Make your projector headlights even more cutting-edge the easy way. Projektorz Headlight Covers highlight the hard-eyed look of your factory lamps with focused lines that accentuate your front end. They're also a degree of impact protection, deflecting stones and other lens-cracking debris.
For the ultimate custom look that packs some street cred, Projektorz Headlight Covers are ready to paint-match with your ride's finish-a seamless appearance straight out of a car show. Or, Projektorz look great right out of the box with their flat black finish.
What's even better, Projektorz install in seconds with no tools, no drilling and no special parts. Just pop `em on with the pre-applied adhesive and you're ready to roll-a huge custom look in no time at all. And, your AVS Projektorz Headlight Covers are sold in pairs with a 90-day warranty.
53 Customer Reviews
Sort Reviews By:
Reviewed by Richard E D (Plantsville, CT) Reviewed for a 2011 Chevy Colorado — Dec 28, 2011 5:44 AM
Installion of the projektorz was very easy and only took a few minutes. The fit was good and the new appearance is also good. Gives the front end a new look that is appealing.
Reviewed by adam h (Tamarac, FL) Reviewed for a 2001 Nissan Frontier — Sep 24, 2009 6:43 PM
would have been perfect if the drivers side headlight cover fit perfct like the passenger side. Had to put two pieces of double sided tape (not included)to hold the outside corner down flat against the headlight! Still achieved the new headlight look i was looking for. a little pricey but still cheaper then new headlight...Satisfied!!!
Reviewed by John S (Marshall, TX) Reviewed for a 2013 Ford Edge — Dec 13, 2008 5:05 PM
It was very easy to install the Projectorz Headligt Covers; its takes less than 30 minutes. One must take caution however. To insert the lower bent tip, use a cloth over a spatula to avoid scratching the paint. It looks jolly good on the 2007 Stang GT
Reviewed by William T (Seattle, WA) Reviewed for a 2005 Chrysler Town and Country — Nov 18, 2008 11:57 PM
They look good, are easy to install and reasonably priced. It would be better if the cut-outs for the headlights were taller so that they didn't obscure the top portion of the headlight beam. Other than that, they fit good. I'd like to find a better installation than double backed tape and I wouldn't mind the extra effort to acually attach a mounting screw or two. I'd buy them again any way. Rude
Thank you for submitting your question. Please allow 24-36 hours for your question to appear on this page.