Arriving home on time or getting towed to the garage after a fender bender often boils down to one simple factor: if the other person can see you or not. Taillights alone aren't enough to get you noticed when you're out on a busy roadway surrounded by sleepy commuters. Make sure everyone is paying attention to you with the Anzo LED Tailgate Spoiler.
These Anzo LED Tailgate Lights turn heads in more ways than one. Connecting right to your rig's electrical system, they flash in unison with your taillights for maximum visibility. Flip the turn signal, and it blinks along. Throw it in reverse, and the clear center bulbs light up. Step on the brakes, and the whole bar comes alive.
Unlike most tailgate light bars that mount along the bottom edge of the bed, the Anzo Tailgate Spoiler perches up at the top where no one can escape it's fiery LED bulbs. It's custom sculpted to mount directly in place of your stock tailgate cap, so it looks factory installed and doesn't require drilling. Plus, yours comes with a One Year Warranty against manufacturer defects.
Reviewed by Michael C (Salisbury, MD) Reviewed for a 2010 GMC Sierra — Apr 30, 2014 1:50 AM
The ANZO LED Light Bar for the GMC/Chevy Trucks puts off a light as equally bright as your tail lights. By sitting higher in the air it definitely lets people know behind you what your intentions are. Not to mention, I with the many different ways it lights up, it is cool looking. A great way to impress other drivers and be safer on the road. The only negative would be that the wires are not long enough as I hard wired mine and had to extend them to get a proper fit.
Reviewed by Robert P (SPRINGFIELD, IL) Reviewed for a 2007 Chevy Silverado — Feb 20, 2014 6:34 AM
This item worked and fit very well except when I wore the reverse light it has no function ... But it still turns signals left and right and brake light but the reverse cord was even present and it's didn't work out of box
Reviewed by angie s (EL PASO, TX) Reviewed for a 2012 GMC Sierra — Mar 21, 2013 2:10 PM
Although it came without any instructions, the installation was fairly simple. I had to change my original towing connection and then I plugged in with a 4 pin connector. The LEDs are bright and I tested them before placing the LED spoiler into the truck (with the 3M tape). A bit of Goo Gone will remove the existing sticky tape. There is a hole large enough at the bottom of the tailgate to wire the 4 pin connector and the white ground wire. To remove the existing screws, be sure to use a T30