Automotive Lights Reviews

The lights look great! If you know basic wiring, they can be a pretty easy install. Most people, as myself, would surely appreciate a little better wiring setup for the F250 lights. There are a lot of wires that need to be connected and I sure the manufacturer could have combined some to make it even easier. Also would have been nice to include LED or blue bulbs for the factory bulb that goes into the eyebrow section. The stock bulb certainly looks out of place. And I know it isn't manufacturer issue alltogether, but the lights were way out of alignment and it is a real pain on the F250 to adjust as you have to completely remove the lights to adjust, taking extra time. But in the end, these lights do get a ton of compliments!

Installed on a 89 CRX, looks great and the quality is good. but there is slight fit problem on the passenger side light. I have an AEM cold air intake and installing the light required me to take off the whole pipe. After installing the light and re-aligning the intake, the back of the light housing scratches up against the pipe heavily. I tried putting silicone rubber between the points of contact, but the sharp edge of the light housing cuts thru it. So now my purdy blue intake pipe is grazed! Given that CRXs have tightly cramped engine bays, I'm sure that this problem doesn't affect all cars that have cold air intakes. I just wish there would have been a specific warning for this.

I had no problems with the install of these great looking, lifetime warranted lights. All necessary hardware and exact instructions are provided including a quality wiring loom, switch, regulator, brackets, nuts, bolts, terminals and tye-wraps for a professional looking install. These lights give off a very bright yellow light that cuts through the densest fog I've ever encountered. I love the way they look on my grill guard. This is quality folks! All delivered, as promised, right to my door at a low price and free shipping from autoanything. I will buy from these guys again!

With the PlasmaGlow Fire & Ice LED Tailgate Bar you will definitely be able to be seen. I ordered these lights because my truck has solid black tail lights and the cops told me my lights werent bright enough at night time. So i stumbled across this tailgate bar ordered it and installed it now the cops dont tell me anything. I took it by the police station and they said it was fine. So those of you who have a problem like me or just want some extra lights i recommend these it took me about 10-15 minutes to hard wire install. Wouldve taken about 30 sec if i wouldve just plugged into the 4pin trail harness.

These lights work great!!! If you have a little bit of electrical and wiring knowledge the wiring will be no problem for you. Though seeing the wiring harness, it was scary to look at, but after taking a moment longer to look you realise they made a very good wiring harness so that all you have to do is plug and play. Luckily I found a grommet to poke the tiniest of holes in to run the wires into the cabin for the switch. Mounted my lights on the bull bar and had no troubles worked great and the Off-Road Lighting system lights up the back roads like no other. Never have a deer surprise you when you run these babies!!