Dee Zee Brite 2003 Ford F150
Posted on 11/11/2009 by Mark G. - 2003 Ford F-150 (Beaumont,CA)
0 of 0 people found the following review helpful.

Appearance

Ease of Installation

Price/Value

Quality
"Product arrived in very good condition with all the parts. Installation required a good deal of effort. The running boards had no holes drilled. The top edge of the boards required the drilling of 1/4" holes that had to be matched to the holes in the frame of the truck. Two support brackets for each board had to be attached to the frame by drilling two holes in the frame and then two holes in the surface of the running board. Finding a good mounting surface on the frame was difficult and I had to cut away one bracket to make it fit. The boards had to be leveled while tightening up all of the bolts, and this required some finesse. I am quite satisfied with the end result but it was definitely more work than I thought it was going to be. The 4" drop on these boards is exactly what I was looking for to make it easier for my wife to enter and exit the truck."
Was this review helpful? Yes
No
Posted on 03/14/2007 by John B. - 1999 Dodge Ram (American Canyon,CA)
10 of 11 people found the following review helpful.
"They are nicely built and installed easily. They arrived in perfect condition and the instructions where clear. I would have rated it perfect but it was short some washers and bolts needed to complete the install. There was a couple holes in the bag of hardware."
Was this review helpful? Yes
No
Replacment running boards
Posted on 05/30/2006 by Raymond J K. (North Smithfield,RI)
10 of 12 people found the following review helpful.
"I purchased the front running boards to replace a damaged set which was caused by accident. I was not able to find a direct replacement locally, but AutoAnything had the connection! I was amazed of the new mounting system.The boards went on in about 15-20 minutes per side, with adding a rust preventive solution to everything. The new style does not connect to the frame and cab, just the cab, but it is very rigid (uses factory located holes in cab). This also cuts down on drivetrain transmitted noise! The originals on my truck were about 8 years old, and the new style mated nicely with the rears (level and protrusion) .Nice product and minimal installation time, what more could you ask for? This complete set-up looks awesome on dually trucks, and it keeps debris off the cab and rear flares."
Was this review helpful? Yes
No