We’re sorry. The information you have requested is temporarily unavailable.
Steelcraft 3" Round Nerf Bars Part #223200 Customer Reviews
13 Customer Reviews
Reviewed by Paul W (Downers Grove, IL) Reviewed for a 2014 Jeep Grand Cherokee — Jun 15, 2014 11:47 AM
The directions weren't perfect (parts didn't quite match up) but it only took me about two minutes to puzzle things out. The installation took me about an hour and a half on my back in a driveway. The only difficulty was due to a wiring harness that was in the way (Jeep's fault, not Steelcraft). The quality is solid. If anything, my Jeep's undercarriage will give way before the nerf bars do!
Reviewed by Cameron T (Naples, FL) Reviewed for a 2014 Jeep Grand Cherokee — Jun 04, 2014 2:37 AM
I'm 67 and pretty handy, I followed the directions and thanks to all the wholes on my Jeep and all the right parts that came with the steps being in the right places. It took me about an hour a side. Make sure you leave every thing loose and then tighten all the nuts and bolts last. Very nice.
Reviewed by John M (FORKED RIVER, NJ) Reviewed for a 2012 Jeep Grand Cherokee — May 02, 2014 2:27 AM
They have a nice look to them. the brackets are very strong. some tubes i have had the support brackets are very flexible.
Reviewed by Caitlyn C (LIBERTY HILL, TX) Reviewed for a 2011 Jeep Grand Cherokee — Oct 28, 2013 5:40 PM
My husband and I installed these in a little less than an hour and a half. We worked on one side together, and I did the other side alone. There were a couple parts of the instructions that were a little unclear. However if you count out the parts/nuts/bolts, it's easy to understand. But if you can put a bolt through a hole and a nut on a bolt, you can install these no problem. Just be sure you have a socket set (or borrow one).
Reviewed by James B (ADAMSVILLE, AL) Reviewed for a 2012 Jeep Grand Cherokee — Dec 20, 2012 3:21 PM
My wife loves her new Nerf Bars. They look great. The only thing I found sub par was the installation instructions. Sort your parts, do one side then the other side will be a breeze.
Reviewed by timothy p (mansfield, CT) Reviewed for a 2004 Jeep Wrangler — Oct 19, 2012 8:16 AM
they have very strong mounting brackets and installed in about 2 hours on the ground . no jacking or lift required. the bars them self are very thin but look great.
Ships Between 3/29 - 3/31
- What Do You Drive?
- steelcraft nerf bar reviews
- steelcraft 3" nerf bars honda pilot
- 5 inch oval stainless nerf
- go rhino! dominator ii series truck steps d24176b
- land rover running boards
- range rover nerf bars
- custom side steps
- side steps for f150 truck
- 2011 tundra step bars
- ford f-150 running boards
- discount custom floor mats
- custom auto dash covers
- custom car bras vehicle