Your Cart Is Empty

1993 Ford Bronco In-Line Modules

Have a Question?
Have a Question? Ask a product expert! (800) 874-8888 Live Chat

  • shipping icon
  • Not Rated Yet

 

View all reviews for this product

There are no customer reviews for this product

You may only compare up to 5 products at a time.
Please select at least two products to start comparing.

Latest Customer Reviews

Jet Performance Module Reviews


More power, better shifting, higher RPM.

Reviewed By Tom R (SeaTac, WA) Reviewed for a 1993 Ford Bronco —10/13/2005 4:45 AM

93 Ford Bronco XLT 5.8L (351CID); The directions said to remove the EEC from inside the cab, you need to loosen the back half of the left inter fender well and pull it out through the engine bay. It is on the far left side of the firewall. 1 bolt holds on the wiring harness (100 or so wires). 2 nuts hold a rubber seal over the EEC. Pull out the EEC and plug in the Jet PCM. There was a small metal tab on the back of EEC that had to be removed. Then just reverse to install. Out of all the upgrades I have done as far as time and money this was the best. K&N Cold Air Induction Kit, A complete MSD Blaster Ignition System and a complete Gibson 3 inch Mandrel Bent Exhaust with Headers.

View More Reviews