Reviewed By Fred K (EMORY, TX) Reviewed for a 2006 Dodge Magnum —10/23/2012 7:23 AM
I just want a small unit that i could mount. It will be used to air up what i need to air up when i'm on the road..
Reviewed By William K (Arlington, TX) Reviewed for a 2015 Ford F-250 —6/18/2015 9:08 PM
After reading the installation instructions, I decided the best place to install the system was in the truck bed. The system was assembled on a 8 inch by 12 inch aluminum plate and mounted to the front bulkhead of the bed on the driver side. The wires were run to the engine compartment and connected accordingly. The +12 volt wire via 15 amp fuse was connected to upfitter switch #1. This makes it easy to check everything except air bag connections without getting under truck.
Reviewed By Scott M (SHERWOOD, OR) —3/4/2015 8:38 AM
Ive run lots of 12v compressors and have gone to exclusively engine driven mechanical compressors to provide enough air w/o a power plant on board. This 12v unit flows as much and is 100% to 200psi. Couple deep cycle 6volts and its set.