Reviewed By Eric B (Guffey, CO) Reviewed for a 2008 Dodge Sprinter —6/30/2011 12:17 PM
Kit was very complete and would have rated an Excellent if it was a"No Drill" kit. I hate drilling a frame and hope it doesnt cause problems with frame strength.
Reviewed By William K (Arlington, TX) Reviewed for a 2015 Ford F-250 —6/18/2015 9:08 PM
After reading the installation instructions, I decided the best place to install the system was in the truck bed. The system was assembled on a 8 inch by 12 inch aluminum plate and mounted to the front bulkhead of the bed on the driver side. The wires were run to the engine compartment and connected accordingly. The +12 volt wire via 15 amp fuse was connected to upfitter switch #1. This makes it easy to check everything except air bag connections without getting under truck.