Reviewed By stephen b (CANTON, PA) Reviewed for a 2013 Ford F-250 —7/6/2015 5:20 PM
The airbags are great and the quick shot works great for our camper.
Reviewed By William K (Arlington, TX) Reviewed for a 2015 Ford F-250 —6/18/2015 9:08 PM
After reading the installation instructions, I decided the best place to install the system was in the truck bed. The system was assembled on a 8 inch by 12 inch aluminum plate and mounted to the front bulkhead of the bed on the driver side. The wires were run to the engine compartment and connected accordingly. The +12 volt wire via 15 amp fuse was connected to upfitter switch #1. This makes it easy to check everything except air bag connections without getting under truck.
Reviewed By Chester F (Clarksville, IA) Reviewed for a 2012 Ford F-250 —8/16/2013 9:29 PM
I installed the in cab dual control system to compliment my Ride Rite Air bags. the installation was pretty easy, my truck had a good mounting spot but I had to move my brake controller to the small cubby hole in the dash. It fit there fine with the Firestone in-cab controller just below it. I attached the illumination light wire to the 4 wheel drive selector switch illumination light. It works like a charm, now I can level my truck camper when loaded and also when I park on uneven ground.