Pace Edwards JackRabbit Tonneau Cover

F-350 Super Duty

Posted on 11/02/2007 by Milton J R. - 2001 Ford F350 (Monroeville,OH)

1 of 1 people found the following review helpful.

"Nice cover. Not sure about the snow load it will handle. Took a while to figure out that the side rails don't just slide in like the instructions make you think. Had to put in on an angle about half way back to get the cover stop into the cutout in the underside of the rail, then level out and slide it in. It's best to keep tailgate closed when installing side rails to keep the rails from falling off bed side and into the bed when installing the rails. The bolt covers on the back of the canister hits the top bed rail in the front of the box, throwing the cover alignment out of whack with the side rails. Rail clamps are a little tricky to negotiate into place and assemble."

Was this review helpful? Yes No

Jack rabbit installation

Posted on 10/20/2007 by Tom M. - 2002 Ford F250 (Kansas City,MO)

0 of 0 people found the following review helpful.

"Overall, not bad. Two people would have sped up the installation. Guidelines were silent regarding how to tighten the rail clamps. I learned not to overtighten them as they had a tendency to twist rail inward causing it to bind with the rollback. There was no mention of when to remove the adhesive cover on the weather stripping under each rail. It looks great ut after a trip through the car wash, I was disapointed at the amount of water that enter the truck bed. We'll see what happens in the rain."

Was this review helpful? Yes No

Acceptable, but could be better.

Posted on 10/04/2007 by Glenn C. (Nokomis,FL)

0 of 0 people found the following review helpful.

"Overall its not a bad product, but not a great product either. The fatal flaw of the Jackrabbit is the engineering associated with where the rails attach to the canister. Extremely difficult to fit and I expect after a few years of vibration, the canister will likely loosen or seperate from the rails. Time will tell. Certainly there is a better design and Pace Edwards needs to address this engineering flaw."

Was this review helpful? Yes No

poperven

Posted on 10/04/2007 by William E. - 2007 Chevy Silverado (Brooklyn,MD)

3 of 3 people found the following review helpful.

"this works great for pulling my 5th wheel i can clore it up to the hitch"

Was this review helpful? Yes No

Toyota Tacoma installation

Posted on 09/28/2007 by Gregory R. - 2007 Toyota Tacoma (Houston,TX)

3 of 3 people found the following review helpful.

"Was sent the wrong set of instructions which resulted in an additional two hours of labor. The kit was fairly easy to set up once the correct instructions were received. The fit and finish quality is not that great and requires a lot of adjustment to square it up to the bed for a professional look so time is not one hour. Bed cover retracts easily when aligned properly."

Was this review helpful? Yes No

fx2

Posted on 09/25/2007 by Jonathan L. - 2007 Ford F150 (Queen Creek,AZ)

0 of 0 people found the following review helpful.

"well after reading a few review what got my attention about the pace edward was that it flex when going 60+ to tell you the truth it does but what my concern was will it be loud and am i gonna hear it? well the answer is NO you can see it flex a bit when looking in a rearview mirror beyong that you can't hear it and that was the biggest concert for me. as the product the product is great took me 45 min. to put by myselft unlike everyone else in here i didn't have a problem with the instruction the instruction was right on only problem i have is the draining hose it's too loose and needs to be a bit bigger so it will stay on other than that i love the product this is the second item i bought in autoanthing and trust me it won't be the last."

Was this review helpful? Yes No

Don from Wisconsin

Posted on 09/19/2007 by Don A. (Darlington,WI)

0 of 0 people found the following review helpful.

"The instructions were very good and two of us installed it without any problems. Works like a charm. A tip on spring replacement; Remove the covers off the rear of the rails (one pop rivit to drill out on each) roll the cover back untill it sticks out the rear,appx a foot. Then you can remove the screws and the spring assembly without taking everything off the truck. Install the new spring assem. wind up spring, screw down cover and this is very easy to do also."

Was this review helpful? Yes No

Bobby D.

Posted on 08/30/2007 by Sue D. - 2007 Toyota Tacoma (Flintville,TN)

2 of 2 people found the following review helpful.

"Received the wrong instructions, realizing it after wasting 2 hours, thinking it was a generic instruction applicable to all. Then went to PE website and downloaded correct instructions. Tackled it the next day and put it on w/n 2 hours with proper instructions. However, missing bolts prompted a trip to hardware store and a missing lock, required a call to PE to send one. Installation and use of strap w/n instructions poor (had to figure it out on my own). Not too thrilled about the plastic cover over the cannister (photo not a representation)...but, will use 303 protectorant and should prevent any fading. I guess for the money, it meets my expectations overall. PE needs to look at quality control."

Was this review helpful? Yes No

Pace Edwards Cover

Posted on 08/28/2007 by Greg H. - 2007 Dodge Ram (Waukesha,WI)

4 of 4 people found the following review helpful.

"The cover is great. Install was easy. It flaps at speeds above 35 which is not the best, but I will figure out a way to brace that."

Was this review helpful? Yes No

JackRabbit Tonneau

Posted on 08/16/2007 by Kenyon R. - 2005 Nissan Titan (Lexington,NC)

1 of 1 people found the following review helpful.

"Nice cover and looks great. Instructions were a little hard to follow but still managed to have it completed in a little over 1 hour."

Was this review helpful? Yes No

Excellent choice from A-Z by Kyle in Nebraska

Posted on 08/10/2007 by Kyle P. - 2008 Ford F250 (Kearney,NE)

1 of 1 people found the following review helpful.

"Excellent choice, By saying this I mean absolutely a breeze to install, Fits like a glove, looks great and operates just as good. I have put it on my 2008 super duty and absolutely love it. Would reccomend this for use to anyone I know, And feel great about it. Kyle, Nebraska"

Was this review helpful? Yes No

Pace Edwards JackRabbit (2007 Toyota Tundra)

Posted on 08/07/2007 by Lamar G. - 2007 Toyota Tundra (Gulfport,MS)

1 of 1 people found the following review helpful.

"Great product. Installation took about 2 hours (we're slow)and I would advise getting a friend to help. The cover is extremely smooth in operation and it looks terrific. Am using it in conjuction with a BedRug. Very well engineered and a good value for the price. Nice product Pace Edwards!"

Was this review helpful? Yes No

great cover

Posted on 07/27/2007 by Steve K. - 2007 Toyota Tundra (Roseville,IL)

2 of 2 people found the following review helpful.

"this was a great buy. the cover went on easy and fit great"

Was this review helpful? Yes No

Cover does good job.

Posted on 07/14/2007 by Brian S. - 2007 Ford F150 (Utica,NY)

0 of 0 people found the following review helpful.

"I thought the cover was easy to install. Looks good on my truck."

Was this review helpful? Yes No

Tundra tonneau cover

Posted on 07/08/2007 by John W. - 2007 Toyota Tundra (Sonora,CA)

0 of 0 people found the following review helpful.

"Arrived per schedule in good shape. Unit is working fine - needs a better seal at the front end of the bed. Instructions are minimal."

Was this review helpful? Yes No

Jackrbbit Cover

Posted on 07/07/2007 by Robert T. - 2007 Dodge Dakota (Blaine,WA)

0 of 0 people found the following review helpful.

"Easy to install but you must follow instructions. Works great"

Was this review helpful? Yes No

Truck cover

Posted on 07/03/2007 by Bill A. - 2007 GMC Sierra (Carrollton,TX)

1 of 1 people found the following review helpful.

"good product. instructions were not as clear as they could be and the photos need to be much larger and more detailed."

Was this review helpful? Yes No

o7 silverado

Posted on 06/28/2007 by Richard M. - 2007 Chevy Silverado (Phoenix,AZ)

1 of 1 people found the following review helpful.

"instructions were a little unclear but not that bad. It looks awesome"

Was this review helpful? Yes No

Damon

Posted on 06/28/2007 by Damon K. - 2007 Ford Ranger (Athol,ID)

0 of 0 people found the following review helpful.

"I like the product and the quick service I received."

Was this review helpful? Yes No

Great choice

Posted on 06/24/2007 by Garland M. - 2006 Chevy Silverado (Fort Stockton,TX)

1 of 1 people found the following review helpful.

"Very easy to install. I gain 2 miles a gallon on gas. It looks really sharp."

Was this review helpful? Yes No

GREAT COVER

Posted on 06/20/2007 by David T. - 2008 Ford F250 (Springfield,IL)

0 of 0 people found the following review helpful.

"THIS COVER LOOKS GREAT,BUT BE SURE TO APPLY 303 PROTECTANT OR SIMILIAR PRODUCT.A RELATIVE HAS THE SAME COVER,BUT HE FAILED TO PROTECT IT AND THE FINISH REALLY LOOKS DULL AFTER ONLY 2 YEARS.INSTRUCTIONS FOR INSTALLTION COULD BE UPGRADED. FOR SECURITY YOUR TAILGATE MUST HAVE A LOCK FOR USING THIS TYPE OF COVER"

Was this review helpful? Yes No

Installation

Posted on 06/15/2007 by Rick B. - 2004 Chevy Silverado (Marion,IN)

0 of 0 people found the following review helpful.

"Didn't really have any trouble installing the cover,but I had read the reviews in the online catalog and was careful to look close. Love the cover, but at 75 mph the wind really makes it bounce."

Was this review helpful? Yes No

great

Posted on 06/14/2007 by Terry O. - 2006 Toyota Tundra (Stevensville,MD)

0 of 0 people found the following review helpful.

"easy install and looks great"

Was this review helpful? Yes No

Love the Pace Edwards JackRabbit

Posted on 06/12/2007 by Stephen M. - 2003 Ford F350 (Land O Lakes,FL)

0 of 0 people found the following review helpful.

"The cover was easy to install and looks great! Could use some sort of u shaped grove at the tale gate to keep the cover from flexing up and down at highway speed travel."

Was this review helpful? Yes No

Awesome! If you can get it installed?

Posted on 06/05/2007 by Donald C. - 2007 Chevy Colorado (Hickory,PA)

0 of 0 people found the following review helpful.

"Installed on a 5' bed, crew cab, Colorado. Finished product looks and works fantastic. Installation is a real challenge. Step 1: Read the directions VERY carefully. Step 2: Takes two people. Bring a friend."

Was this review helpful? Yes No