We’re sorry. The information you have requested is temporarily unavailable.
TonnoPro TonnoFold Tri-Fold Tonneau Cover Part #42-204 Customer Reviews
36 Customer Reviews
Reviewed by edward o (EL PASO, TX) — Jun 07, 2017 7:14 AM
Although this cover the bed of the truck, it's not exactly a tight fit, which causes a bit of water leakage. I believe this could easily be fixed by changing the locking mechanisms in the back.
Reviewed by Allie D (PUNTA GORDA, FL) Reviewed for a 2011 Dodge Ram — Dec 23, 2016 8:14 PM
We had a roll and lock on our previous truck and when we traded in we never got a new one installed. We were headed on a trip from Florida to Maine in winter and needed a solution. After some research I was impressed with the reviews on this one plus the no tools install. It arrived on time and took no time to set up. We also had the truck detailed and no water got in. (Hubs said no daylight was visible from under the cover when he crawled in. Once in Maine it snowed and the bed stayed dry.
Reviewed by Tamatha H (Scappoose, OR) Reviewed for a 2003 Dodge Ram — Mar 15, 2016 9:10 AM
I purchased a cover for my 2003 Ram, the front and rear corners do not sit flat against the bed rail, in turn leaving gaps. The securing devices are as tight as they can go and there isn't anything else that can be done.
Reviewed by Charles M (Ashland, OH) Reviewed for a 2012 Dodge Ram — Oct 24, 2015 6:54 AM
Easy to put on, but you can see the cover lift when you're driving down a windy roadway. Let the top settle in for several days in the sun and resecured it again seemed to help. Next time I will option for the hard top.
Reviewed by Kelly O (HIGHLANDS, TX) Reviewed for a 2014 Dodge Ram — Oct 14, 2015 5:35 AM
Cover slides around on bed, the wind vibrates and baffles the rear and with it folded it catches a lot of wind causing it to baffle quite a bit. Appearance is great but apprehensive about how long the clamps will last until it blows off going down the road.
Reviewed by Peter p (WALLA WALLA, WA) Reviewed for a 2015 Dodge Ram — Mar 30, 2015 10:49 AM
This is for an 8ft bed. The forward crossbar is too far from the front and allows wind to pick up the leading edge of the cover. The cross bars are metal except where the clamps slide on the ends. This is a design flaw as it is the weekest point and should be the strongest. The plastic ends that hold the clamps immediately bent with the wind deflection. If they were metal or if the forward crossbar was closer to the front of the bed it would be fine. I am looking for resolution from the company. Likely, I will end up throwing it in the garbage. Do not buy this product until this problem is resolved.
- Get a TonnoPro 4 Free Gifts Pack With Purchase - A $69.00 Value!
Ships By 6/26
- What Do You Drive?