When your trailer hitch is loaded down with a couple tons, a brake controller gives you the power to stop in time. But, they can be a bear to install without the right gear. Simplify the installation with a Draw-Tite Brake Controller Wiring Harness. With easy plug-n-play connectivity, this kit takes the trouble out of connecting your brake controller.
Forget about fumbling with frayed wires and electrical tape. Your Draw-Tite Brake Controller Wiring Harness is completely custom-designed for your year, make and model. Just plug it in, and enjoy the security of safe stops every time you hitch up. What's more, the Draw-Tite wiring harness comes with a 1-year warranty.
Reviewed by Jerry I (Harker Heights, TX) Reviewed for a 2006 Ford Econoline — Sep 22, 2007 5:29 PM
This harness fits perfectly as a plug-in to the brake controller found under the dashboard of my 2006 Econoline 350 XLT extended length van. I used it to change the originally 4 pin tow trailer assembly to a full 7 pin towing capability (adds brake control capability instead of just signal lights). I went to the dealer and they couldn't order just this part, they had to order a whole kit which cost much more! U Haul was able to wire my vehicle with installation of one of their hitches. Controller was well-priced (I compared with 3 other online retailers) and arrived within 1 week of ordering.
Thank you for submitting your question. Please allow 24-36 hours for your question to appear on this page.
Asked by Jack G.
Jan 03, 2012 7:59 AM
2011 Nissan Titan
I removed my Draw Tite Activator 2 from my 2003 Silverado and need to install it in my 2011 Nissan titan and I have the factory elec break hardness, but don’t know the color code for the wiring from the controller to hardness.