Your Cart Is Empty
Video
Images
Showing 1 - 7 of of 9
Video

We’re sorry. The information you have requested is temporarily unavailable.

CURT Receiver Hitches Part #13256 Customer Reviews

Average Rating

13 Customer Reviews

Toyota Corolla and Sienna

Reviewed by Keith F (Motley, MN) — Jun 04, 2011 11:04 AM

Was this review helpful?
Yes   No

Hitches for both vehicles fit perfectly. Toyota prepped each vehicle with welded nuts in the frame which made installation easy. However, there is no protection for the nuts from corrosion. If you do buy one for a toyota, get yourself a 20mm x 1.25 tap so you can clean out the threads and installation will go smooth and easy.

easy job

Reviewed by Dan B (Lubbock, TX) — Jun 04, 2011 10:57 AM

Was this review helpful?
Yes   No

i received this hitch in just a few days,had it installed in about 40 minutes.very impressed with tracking emails and followup service.THX

Great Hitch

Reviewed by Robert C (Bismarck, ND) Reviewed for a 2008 Toyota Sienna — May 05, 2011 12:06 PM

Was this review helpful?
Yes   No
4 of 4 people found the following review helpful.

Great Hitch, great instructions, fits like a glove.

Hitch

Reviewed by Albert B (Oceanside, CA) Reviewed for a 2011 Toyota Sienna — May 02, 2011 10:55 PM

Was this review helpful?
Yes   No
1 of 1 people found the following review helpful.

Great product works great. Easy to install.

Easy to install

Reviewed by Jamie P (Waukesha, WI) Reviewed for a 2011 Toyota Sienna — May 02, 2011 10:16 AM

Was this review helpful?
Yes   No
7 of 7 people found the following review helpful.

(2011 Sienna)The hitch went on really quick, once I figured out where to cut the hole in the plastic panel. I left the panel installed and just cut it with a utility knife. everything bolted in nice. I used a floor jack to support the hitch while I started a bolt on each side, bolt go in on a slight angle. One person operation, 30 minutes to install. The wiring harness to took some time. The longest being routing the wire under the vehicle to the battery. From start to finish it was over an hour to complete. It was not difficult just time consuming to get the wire in the right place under the car. A lift would have made it so much easier, I used a couple of blocks under the tires on the drivers side to give me some clearance. It would have been nice if the harness tied into the circuit for the rear power seat stow option. The wires are right there. Our Van is an LE Model and thus the don't have the power stow rear seats. But the electrical is there.

perfect

Reviewed by Jeremy Y (Gilbert, AZ) Reviewed for a 2011 Toyota Sienna — Apr 20, 2011 8:22 PM

Was this review helpful?
Yes   No
1 of 1 people found the following review helpful.

I had it installed in 20 min it was perfect

2007 Sienna

Reviewed by Chris H (Placentia, CA) Reviewed for a 2007 Toyota Sienna — Mar 28, 2011 8:43 PM

Was this review helpful?
Yes   No
1 of 1 people found the following review helpful.

Delivered promptly in box. No missing parts. Simple instructions. Make sure you have the right tools (torque wrench, socket, at least a 6" extension). Didn't have to take down my tailpipe, but would obviously be easier to install if I did. Used my hydraulic floor jack to help suspend the hitch after I hung(wedged it in) the "tailpipe" side in first. Secured the driver side in with a little play then moved to the passenger side. Make sure you clean the mounting surface!

Great

Reviewed by Erik L (Frederick, MD) Reviewed for a 2011 Toyota Sienna — Aug 31, 2010 11:05 PM

Was this review helpful?
Yes   No
1 of 1 people found the following review helpful.

you were the only one who had a 2011 Sienna hitch and the price was right and installation easy. thank you for your help in ordering as well. your customer service rep was absolutely great! will be recommending to any and all who need parts, etc. thanks! edl, Frederick, MD

great hitch

Reviewed by Edward J. B (Ringtown, PA) Reviewed for a 2011 Toyota Sienna — Aug 30, 2010 5:52 AM

Was this review helpful?
Yes   No

Very easy install and looks good

Curt reciever Hitch for 2011 Toyota Sienna

Reviewed by Gerard G (Cumming, GA) Reviewed for a 2011 Toyota Sienna — Jul 15, 2010 4:34 PM

Was this review helpful?
Yes   No
18 of 19 people found the following review helpful.

The hitch came very quickly and was well packaged. The installation was easy and the fit was perfect for the 2011 Sienna. Finish on the hitch is a glossy black. The instructions had us removing the plastic cover that is under the rear of the car so that a rectangular hole could be cut in it to accomodate the driver side mount of the hitch. They don't tell you to replace the cover before you try to install the hitch. The plastic cover is thin and can be cut with a utility knife. Removing the cover was a waste of time, it could be cut, using the measurements supplied in the instructions, while it is still on the car. This would save time and you avoid dealing with all those little fastners.

CURT Receiver Hitches - 13256

(13)

Part Discontinued

This part has been discontinued by CURT . We apologize for the inconvenience.

View all options for this product
Have a Question?
Have a Question? Ask a product expert! (800) 874-8888 Live Chat