We’re sorry. The information you have requested is temporarily unavailable.
CURT Front Mount Trailer Hitches Part #31241 Customer Reviews
13 Customer Reviews
Reviewed by Roger H (MILLBORO, VA) Reviewed for a 2016 Nissan Frontier — Dec 20, 2016 5:18 AM
The 312421 hitch does look good (5 star) once it is installed but that installation (1 star). The bolt holes on the hitch do not line up with the pre-cut threads on the frame. I had to buy a rat tail file to facilitate mounting. A 15 minute job ended up at 2 hours. I did contact Curt by email and phone. They of course deny any knowledge of any poor fit. This appears to be the only hitch made that will 'fit' this truck. Curt needs to go back to the drawing board and own this problem.
Reviewed by Richard G (COLTON, CA) Reviewed for a 2005 Nissan Frontier — Jun 30, 2016 9:15 PM
Great product, fit perfectly and was shipped very fast. Service is great and I will purchase again from this company without worry.
Reviewed by laura k (WINDSOR, NY) Reviewed for a 2008 Nissan Pathfinder — Apr 27, 2016 5:34 AM
Heavy duty. Easy to bolt on, used a jack to hold it up while bolting it on because I'm a woman! But it fit perfectly, just make sure you tighten each side evenly for better fit. If you fully tighten one side, your other side might not line up, and you will have to start over (happened to me).
Reviewed by Glen H (Columbia, MO) Reviewed for a 2015 Nissan Frontier — Apr 16, 2016 8:24 PM
Basically the holes for the four mounting bolts are too close to the sides of the L-shaped portion of the hitch to allow the supplied washers to be used and slight misalignment of the threaded holes in the truck frame and the hitche's drilled holes prevent one from getting the bolts in their intended locations in the frame. I ended up using a Dremel and stone to tediously grind away about 1/8 inch in two of the four holes to make everything work - adding an hour to a half hour job.
Reviewed by Eric Y (Castle Hill, ME) Reviewed for a 2008 Nissan Frontier — Dec 09, 2015 1:55 PM
I recieved my curt hitch and immediatly cut it apart in order to manufacture a sno-way plow mount. It did a great job allowing me to add the third pin needed for sno-way plows to slide in and out of the 2" reciever.
Reviewed by Michael C (NAPLES, NY) Reviewed for a 2014 Nissan Frontier — Oct 24, 2014 11:00 AM
hitch delivered day after I ordered it ! - free shipping. as good looking quality as any other I've had b4 (3). works just fine. HOWEVER , as others have said, the hitch mounting 'wing' brackets where they bolt (2 ea. side) to already drilled and tapped holes in frame were too narrow. I had to take down, and spread with a hydraulic jack between mounting braket/flanges. with the jack was no problem, easy does it here ! also, washers too wide. cut thru 1/2 way, edge to hole b4 mounting !
Reviewed by Ronald N (BRAINTREE, MA) Reviewed for a 2005 Nissan Pathfinder — Jul 30, 2013 9:47 AM
The product states a tongue weight of 350 lbs but upon arrival the hitch is labeled as only 300 lbs. Other than that, install was generally easy, only 4 bolts in stock locations. So far so good. I would recommend to anyone doing light duty activities.
Reviewed by Greg S (Knoxville, TN) Reviewed for a 2009 Nissan Frontier — May 04, 2012 7:07 AM
Ah. So, I screwed up. I got the wrong hitch - I ordered a FRONT instead of a REAR. So, my bad. called up AA and they fixed it without any problems. thanks guys. Love you. The hitch looked great though! I'm sure it would have fit fine. Was particular when I reordered that I got CURT brand and was thrilled with the hitch when I actually ordered it correctly. Good experience. :)
Ships By 6/28
- What Do You Drive?
- curt trailer hitch #31017
- draw tite 75599
- 2008 toyota highlander trailer hitch
- reese hitch toyota highlander
- subaru hitch wiring harness
- tow package for mercedes
- kia soul tow hitch bike carrier
- honda fit trailer wireing
- 2012 gti curt trailer hitch
- 2013 ford escape hitch
- automobile floor mats carpet
- performance exhausts
- tools boxes for trucks