Audi A6 Receiver Hitches

Reviewed By matt a (ALLENTOWN, PA) Reviewed for a 2014 Audi A6 —5/2/2014 8:10 PM

installed as the directions outlined. Always a challenge getting my mitts into tight places, but its on the car and looks decent. ONE BIG CALL OUT - the manual doesnt mention it, but if your car has the "kick to open" trunk release you have to remove the cable and cable guide BEFORE you trim the fascia... I almost cut the sensor cable and absolutely ruined the cable guide. Otherwise a clean install that went well.

Reviewed By Al C (Plant City, FL) —6/24/2017 3:21 PM

Easy installation fits like a glove (not OJ's) lol... looks like it belongs...

Reviewed By Taad J (Fountain Hills, AZ) Reviewed for a 2006 Toyota Tacoma —6/9/2017 8:16 AM

This bolt on receiver wasn't quite bolt on;I had to enlarge the slotted bolt holes inward a bit, because my bumper holes were 8" on center. The rear small bolts don't line up with any place you could effectively drill and bolt to on the 06 Toyota Tacoma bumper. The two large grade 8 bolts do the job well though, sucking the hitch up to the bumper plate very tightly. This hitch will do its job just fine.