Your Cart Is Empty

2011 Chevy Suburban Receiver Hitches

Have a Question?
Have a Question? Ask a product expert! (800) 874-8888 Live Chat

  • shipping icon
  • Not Rated Yet

 

View all reviews for this product

There are no customer reviews for this product

You may only compare up to 5 products at a time.
Please select at least two products to start comparing.

Latest Customer Reviews

Draw-Tite Front Mount Trailer Hitches Reviews


Fits 2010 3/4 ton Suburban 4x4

Reviewed By Browning M (old hickory, TN) Reviewed for a 2010 Chevy Suburban —4/21/2016 9:07 AM

Fits the frame well of a K2500 2010 Suburban. The trick is fitting the plastic bumper. I was able to make most of the cuts from behind with a drill and 4.5" angle grinder with a cut-off wheel. I had to also cut the bumper where the tow hooks are to fit. The initial hole should be a bit higher in the middle of the plate hole, but the excess hole works for the Anderson SB175 plug. The 1/2" hole landed in front of the bumper so I had to take it out and drill it to 5/8" for the pin.

View More Reviews

CURT Front Mount Trailer Hitches Reviews


Front Mount Hitch

Reviewed By Louis M (Duluth, MN) Reviewed for a 1994 Chevy Suburban —12/21/2015 7:11 AM

Fit and finish was very good. The hitch was easy to install and contained quality hardware that worked well for the application.

View More Reviews

CURT Bumper Mount Hitch Reviews


Decent Hitch but work required to mount

Reviewed By Taad J (Fountain Hills, AZ) Reviewed for a 2006 Toyota Tacoma —6/9/2017 8:16 AM

This bolt on receiver wasn't quite bolt on;I had to enlarge the slotted bolt holes inward a bit, because my bumper holes were 8" on center. The rear small bolts don't line up with any place you could effectively drill and bolt to on the 06 Toyota Tacoma bumper. The two large grade 8 bolts do the job well though, sucking the hitch up to the bumper plate very tightly. This hitch will do its job just fine.

View More Reviews

Year Range For Chevy Suburban Receiver Hitches