Reviewed By Eagle O (MELROSE PARK, IL) Reviewed for a 2003 Chrysler Town and Country —7/9/2015 8:09 PM
Reviewed By JAMES J M (HOMEDALE, ID) Reviewed for a 2003 Chrysler Town and Country —12/13/2012 5:09 PM
INSTALLED WITH SOME DIFICULTY ON 2003 CHRYSLER TOWN&COUNTRY DUE TO LEFT REAR BOLT HOLE ON HITCH WAS ABOUT 1/2 IN OFF HAD TO USE PRYBAR TO MAKE ACCESS FOR REINSTALLING BOLT. OTHER THAN THAT WAS EASY TO INSTALL WITH PROVIDED INSTRUCTIONS. I HAVE BOUGHT SEVERAL DRAW TITE HITCH IN PAST YRS. HIGHLY RECOMMEND THEM.
Reviewed By Gary H (Birmingham, AL) Reviewed for a 2003 Chrysler Town and Country —12/26/2009 7:15 AM
The connector does the job but I was a little disappointed to find that the last note on the instructions was to leave the wires in the Jack Storage Box until you need them. Apparently you have to pull the 4 flat connector from storage to the outside of the vehicle and then close the trunk lid down on the wire. The female end would then be hanging outside to connect to the male end from the trailer. I installed a wiring harness on my 1994 Town and County and all of the wiring came out underneath the vehicle and attached to the hitch next to the receiver...more of a "custom" look. I hope the wires hold up over time after having the trunk closed on them over and over.