Your Cart Is Empty

2010 Ford Escape Hitch Wiring

Have a Question?
Have a Question? Ask a product expert! (800) 874-8888 Live Chat

  • shipping icon
  • Not Rated Yet


View all reviews for this product

There are no customer reviews for this product

You may only compare up to 5 products at a time.
Please select at least two products to start comparing.

Latest Customer Reviews

CURT T-Connectors Reviews

Testing Confusion

Reviewed By Jim S (Shade, OH) Reviewed for a 2010 Ford Escape —3/14/2014 5:18 PM

Installed with all wires on the inside of the vehicle, will pull the trailer light pigtail out through hatch when needed. Confusion - installed the Curt T-connector and then tested with a digital multimeter, measuring battery voltage on each circuit on the trailer plug without energizing any of the circuits. After uninstalling and reinstalling a replacement, through Curt, I found out this is normal. I feel there should be a warning in the packaging, not to check with digital meter.

View More Reviews

Tekonsha T-One Connector Reviews

Ford Escape Tow Wires

Reviewed By ANTHONY S (Jackson, NJ) Reviewed for a 2010 Ford Escape —9/23/2009 7:10 AM

The unit was constructed very well. The installation sheet was a little bit confusing at first, however once you look at the actual vehicle it makes a lot of sense. I ran the main power wire through the frame onmy 2010 Ford Escape straight from the battery to the rear on the driver's side. I installed the wire junction box in the frame of my truck as the rear frame is exposed. i used some of my own heavy duty wire ties to strap it in. I recommend doing the same. Overall to put a new hitch on my truck and wire the harness took 2.5 hours and mostly because the hitch is a little more difficult. Overal, the wiring took 45 minutes.

View More Reviews

CURT Trailer Wiring Adapters Reviews

Convenient Installation. Works Well. Recommended.

Reviewed By Wilbur T (GREAT FALLS, MT) Reviewed for a 1978 Ford F-250 —11/14/2016 9:50 AM

My truck already has a 4-way flat, so this made the installation easier and cleaner. Splicing into wires is a necessary evil at times and this avoids that unpleasantness. The bracket needed a small bend to allow the door to open all the way so the plug-in will fit. This is the one with the LED lights that indicate which pins are working, but I wish I had purchased a separate tester instead. One LED light always stays on. Battery drain isn't a concern, but unnecessarily attracting attention is.

View More Reviews

Helpful 2010 Ford Escape Hitch Wiring Articles