Reviewed By eugene a (CRESTON, CA) Reviewed for a 2013 Toyota Tacoma —1/10/2018 7:10 AM
you need help to put on
Reviewed By Robert B (Freeport, ME) Reviewed for a 2005 Toyota Tacoma —11/28/2017 4:12 AM
When the frame on my Tacoma was replaced by Toyota, I noticed that even the receiver was shot. This Draw-Tite is a good deal for the money. Had it rust proofed at my local Rust Check for longer life.
Reviewed By Taad J (Fountain Hills, AZ) Reviewed for a 2006 Toyota Tacoma —6/9/2017 8:16 AM
This bolt on receiver wasn't quite bolt on;I had to enlarge the slotted bolt holes inward a bit, because my bumper holes were 8" on center. The rear small bolts don't line up with any place you could effectively drill and bolt to on the 06 Toyota Tacoma bumper. The two large grade 8 bolts do the job well though, sucking the hitch up to the bumper plate very tightly. This hitch will do its job just fine.