Reviewed By Donald B (Portland, OR) Reviewed for a 2005 BMW 3-Series —6/30/2016 8:24 PM
More power gain than expected. Made a noticeable difference in throttle response. Very well made and install was a breeze
There are no customer reviews for this product
Reviewed By Nathan F (Matthews, NC) Reviewed for a 2005 BMW 3-Series —2/12/2015 9:17 AM
This is, in my opinion, the best aftermarket intake available for the Gen 3 Mazda6 (at the time of this review). The installation is simple and results in a very well supported intake tube. The heat shield doesn't fully seal the filter off from the engine/radiator heat, but it should be enough to make a measurable difference in inlet temperatures. Overall, I'm very happy with this product.
Reviewed By Dave N (Colorado Springs, CO) Reviewed for a 2005 BMW 3-Series —12/24/2010 3:54 PM
Overall, very good cold air intake system. In my M#, install took a bit, but not too difficult. Instructions were pretty spot on. Some angles to get in and tighten and fit were a pain. Instead of a metal heat shield, I would prefer to have a composite heat shield so air stays cooler even when engine is at temp. I would pay for another composite heat shield if they offered it.