- Free Shipping
Ships Between 4/22 - 4/24
- What Do You Drive?
- Part #:60-12260
We’re sorry. The information you have requested is temporarily unavailable.
Steelcraft HD Front Bumpers Part #60-12260 Customer Reviews
6 Customer Reviews
Reviewed by Michael M (ROCK SPRINGS, WY) Reviewed for a 2017 Dodge Ram — Mar 27, 2018 1:10 PM
Over all I'd give it 3.5/5 stars. It wasn't too difficult to install the bumper in the garage with the help of a friend and the use of an engine hoist. However, the Park Sense sensors are held in with small allen screws and if over tightened they crack the sensor. Also the wiring harness isn't long enough to reach the passenger side sensors. And lastly, the factory fog lights are recessed quite a bit back into the bumper diminishing the effectiveness of the light. Appearance is great though.
Reviewed by Dakota R (GILMER, TX) Reviewed for a 2017 Dodge Ram — Jan 01, 2018 8:04 PM
This bumper is great for the price. Only think I would change is the way the light bar mounts in he bumper. There are slots on both sides where you put the screws in the light bar then slide it in. It would be a much better design if the pieces of plate were solid with holes drilled in them to mount the bar. The way it is now the light bar could easily loosen up and fall out
Reviewed by Joseph A (BEAUMONT, TX) Reviewed for a 2018 Dodge Ram — Dec 14, 2017 5:11 AM
Like the bumper over all. Some rough welds were noted (could have spent a little more time on prep before finishing/painting). The steelcraft bumper did not have a way to re-mount a factory plastic sheild that attached between the radiator shroud and the bumper. Had to remove it. Hope it was not important. The instructions did not mention this. Had some issues with the matching rear bumper as well. Over all it is a good looking bumper and should help in the event of a deer impact.
Reviewed by Trever B (LAYTON, UT) Reviewed for a 2018 Chevy Silverado — Nov 07, 2017 8:06 PM
Received within a week, packaged well but not palletized/boxed. Fairly easy to install but unhappy with the gap between the truck/bumper. OEM fog lights mount up but are mostly restricted because they mount so far inside the bumper, OEM sensors might work, but you reuse the OEM harness which is way too short to plug into the sensors. It'll stop a train, and is a great deal ($849), but realize there are some drawbacks.
Reviewed by Brandon O (JOHNSTOWN, CO) Reviewed for a 2012 Dodge Ram — Jul 06, 2017 6:33 PM
First, the bumper quality & finish is great. The brackets bolted into place and the bumper lined right up. However, this is my first aftermarket bumper and I might have too high expectations. A couple of observations: 1 - it sticks out 14" past the grille. 2 - I would like to raise it up and move it farther back toward the truck, but the adjustment is maxed out.
Reviewed by Jack M (Omaha, NE) Reviewed for a 2017 Dodge Ram — Jun 29, 2017 6:59 AM