We’re sorry. The information you have requested is temporarily unavailable.
Stampede Vigilante Premium VP Series Hood Protectors Part #2153-2 Customer Reviews
5 Customer Reviews
Reviewed by Robert R (Jacksonville, FL) Reviewed for a 2018 Ford F-150 — Feb 07, 2018 6:51 AM
The acrylic materials in the deflector is good quality. My mixed ratings are entirely the result of difficult and in my opinion inadequate installation materials. The plastic expansion screws were inadequate. I purchased some 5/16 x 1/2 inch screws,and rubber washers and slightly drilled the existing holes in the hood to thread them into to attach the deflector. One of the holes in the deflector did not line up with the factory holes in the hood so I had to slightly modify the deflector hole
Reviewed by Patrick P (Sayreville, NJ) Reviewed for a 2015 Ford F-150 — Dec 14, 2017 5:55 PM
Great looking deflector. Do yourself a favor, buy stainless screws before you start. The plastic screws they give you are garbage and are going to strip out. That is my only complaint. If you start with better screws, it will take you 20 minutes to put on.
Reviewed by Edward L S (New Cumberland, WV) Reviewed for a 2016 Ford F-150 — Jun 25, 2017 8:26 PM
The plastic inserts would not stay in the protector. I used clear tape to hold them in place to insert the screws in the holes in the hood of my F150. Also the clamps that go on each end of the protector were to tight. I had to put them in a vise and use a screw driver to pry them open some. I think this is quality product and would recommend it to others.
Reviewed by Keith O (NEW GERMANY, MN) Reviewed for a 2007 Mercury Montego — Aug 19, 2016 6:13 AM
Really like the looks of the Stampede VP protector. Looks to be the same quality construction as my last Stampede which is 12 years old Like that it is wider than the hood to fully protect the fender corners. Installs without drilling. Would give it 5 stars, but the plastic anchors are not secure enough so I installed with 4 3/16" aluminum rivets instead(1/8 to 1/4" grip range). You will use the 2 metal clips to fasten the ends to the hood, plastic film is provided to prevent scratching
Reviewed by Stephan A (MILES CITY, MT) Reviewed for a 2015 Ford F-150 — Jun 03, 2015 2:32 PM
I love the style of the Stampede Hood Protector however, when I tried to install this morning, none of the holes line up to my 2015 F-150 XLT. I'm sending it back and will order another bug shield from you folks.
Ships Between 7/25 - 7/27
- What Do You Drive?
- Part #:2153-2
- No drilling required