Ships Between 9/27 - 10/01
- What Do You Drive?
- Style:4" Single side exit
- Part #:S6104409
- 4" pipe
- 409 Stainless
- Horsepower rating found on timing cover near injector pump
- Includes single-wall polished stainless steel tip
- Lifetime Warranty
- Download installation instructions (PDF)
MBRP Exhaust Systems Part #S6104409 Customer Reviews
4 Customer Reviews
Reviewed by William H (Linden, NJ) Reviewed for a 1992 Volkswagen Jetta — Aug 27, 2011 10:48 AM
Removal was fairly easy, had to cut old system in two places (where rusted)just to speed things up. Followed installation instructions with no problem. Had to loosen bracket on transmission that holds downpipe support which made connecting downpipe to turbo elbow alot easier (V-CLAMP). Had to straighten flange on downpipe and one pipe connection as they were bent during shipment. Put muffler in place supported by jackstand to obtain correct measurement before cutting extension pipe (shortbed only). Measured at least 10 times and still cut it too long, but easily corrected. I think the final cut length was 40 or 41 inches but not 100% sure. Tightened all clamps after adjusting all pipes, put tip on then tack welded each connection so they don't get loose. Also tack welded tip to prevent theft. Sounds great, alittle louder than i thought it would be but its OK.
Reviewed by Russel B (Ligonier, PA) Reviewed for a 2004 Dodge Ram — Jul 02, 2008 1:29 PM
It has been quite a few years since I have installed an exhaust system myself, but this system was easy to install. It took longer to remove the rusted out factory system than it did to install the MBRP system. The only issue I had was reconnecting the "V" band clamp. You may need an extra hand for that part. All parts lined up perfectly with the existing mounts. If I could make a change I would have purchased the 5 inch system. The 4 inch does have a nice rumble. Rus B.