We’re sorry. The information you have requested is temporarily unavailable.
JBA Mid-Pipes Part #2968SD Customer Reviews
3 Customer Reviews
Reviewed by John S (COLDSPRING, TX) Reviewed for a 2016 Dodge Challenger — Apr 19, 2018 9:09 AM
The driver side installed just fine but the passenger side was a mess. The tapered down piece at the back would not slip in to the cat back section. I had to smooth it down and it still didn't fit. I finally cut two slots in the mid pipe and managed to beat it in after a lot of time and work. The O2 sensor threads were a little further back than the stock pipe so the wires to the O2 sensors were a little tight after install. The sound is great and really opens up the car to breath a lot better.
Reviewed by Brad S (Hudson, MA) Reviewed for a 2016 Dodge Challenger — Oct 07, 2017 9:59 AM
The JBA Non-Catted Mid Pipes are of decent quality, the fit and finish was very good as well. I would recommend this product to anyone who is looking for a slight bump in horsepower and torque. There was an increased the exhaust note and my car feels a little more responsive.
Reviewed by Todd H (Elkton, VA) Reviewed for a 2014 Toyota Tundra — Sep 11, 2017 7:15 AM
Ordered the JBA mid pipes for my 2017 392 Challenger, they came quickly, were packaged great and not dented up or anything. Install was a breeze, they basically fell into place, just had to expand the factory pipes at rear some because they factory really crimped them in while tightening. The O2 sensors are stretched a little now, had to remove their harness clips to allow enough room.
Ships Between 7/23 - 7/25
- What Do You Drive?
- Style:3" Piping, without High Flow Cats (409 Stainless)
- Part #:2968SD
- For Off-Road Use Only
- Cannot be shipped to California