Ships By 9/24
- What Do You Drive?
- Part #:SBE702
- Sold in pairs
We’re sorry. The information you have requested is temporarily unavailable.
Skyjacker Sway Bar End Links Part #SBE702 Customer Reviews
6 Customer Reviews
Reviewed by Devon Z (Salina, KS) Reviewed for a 2007 Toyota FJ Cruiser — Jun 30, 2016 8:27 PM
Overall a good product to install on any lifted vehicle. I noticed an improvement in handling while taking corners. Vehicle just felt more planted with less sway. Installation instructions would have been icing on the cake if they were provided. I'm also not overly thrilled about the non-sealed design. I wash my vehicle often so I'm hoping they will hold up.
Reviewed by Kai H (ALLENTOWN, PA) Reviewed for a 2013 Toyota FJ Cruiser — Jun 25, 2015 9:02 PM
This definitely do the job right, that is restore swaybar end links angle on lifted vehicle, and allow more suspension droop before swaybar bind. But using two bushings instead of one bushing + one ball joint like OEM, I kind of concern the longevity of the bushing because I have extended droop. The washers on the frame ends are a little too big, which will contact the frame bracket during flexing. The inner sleeve for the swaybar end is rolled so it has a profound groove with edge.
Reviewed by Jed J (Laguna Niguel, CA) Reviewed for a 2007 Toyota FJ Cruiser — Apr 22, 2014 4:47 PM
The pic is deceiving since they aren't red any longer. But I knew this from looking at skyjackers website. The product was shipped extremely fast and was simple to install with proper tools. I have a coil lift in the rear of my FJ. these helped extend the links to compensate for the lift which really helped my handling on and off road. smoothed out my ride on road and added more articulation offroad.
Reviewed by William S (Sandy, UT) Reviewed for a 2007 Toyota FJ Cruiser — Apr 11, 2013 8:57 PM
These are great additions to my lifted FJ and allow better articulation with the rear sway bar. They are very different than the pic. They are bare metal with quality red bushings. I painted mine to protect the bare metal. They took about 20 minutes to install.
Reviewed by Henry Y (Fort Scott, KS) Reviewed for a 2008 Toyota FJ Cruiser — Feb 25, 2012 3:15 AM